Blockages in the bathroom a frequent occurrence, the occurrence of which is caused by a variety of reasons. In this article we will talk about the main factors that are involved in the occurrence of blockages, as well as decide what means better use of to get rid of them.
What causes blockages
Over time, due to the flushing hair, dirt particles, wool blockages in the pipes are formed. Because of them, in turn, water is unable to pass through the drain further. The formation of plaque on the walls of pipes of different nature, as well affects the fluid permeability is not the best way. The main objective is to determine the blockage formed and that it is up to what point.
In the formation of the plug in an apartment house should be established, the obstruction has arisen in which part of the sewer system. In the event of local clogging, it is necessary to try to clean it on their own. In all other cases, the best solution is to turn to professionals.
If there was a local blockage, then when you open the taps in the kitchen and in the bathroom, in any one place, the water will go through the pipe. In the opposite case - when obschedomovyh clogged, the water will accumulate at two locations.
There are some options for cleaning:
- thermal impact - the drain is filled with boiling water.
- chemical effect - elimination of clogging through a combination of acids and alkalis.
- physical exposure - using cable or dismantling of the siphon.
- vacuum impact - application of the valve.
Cleaning the air eliminator - step by step guide
Almost in every apartment you can find this tool. It is indispensable in the fight to clog. This is the first agent to which should apply in the event of obstruction of water. It is worth noting that remove obstruction in the bathroom is much more difficult than in the same kitchen sink.
Below we describe how necessary to carry out cleaning of pipes, using a plunger. Observe the following procedure:
Step 1. Rubber part plunger carefully greased with vaseline oil.
Step 2. The treated part is placed on the drain hole.
Step 3. Pour in water bath so as to cover 25% water rubber packing tool.
Step 4. Repeat several sudden movements without taking plunger from the hole, the top-down. Then you can remove the blockage surfaced hands.
This method is quite effective against surface obstructions. If efficiency is not the first approach, it is recommended to repeat the procedure again.
Cleaning the rope
If it turned out that the blockage after treatment with plunger, remained in place, you should refer to the plumber's snake.
The standard cable length is equal to 4 meters. To carry out cleaning, it is necessary to put the narrow part of the tool into the pipeline and drive it deeper until such time as the cable you are rested in the blockage. Then, sharp and easy push scrolling, it is necessary to pick up the bulk of clogging on the tip and pull it outwardly, thereby clearing tube. Even if the pipe something remains, it is easily removed with the water current.
Tip! It is recommended that cleaning in pairs: one pushes the wire, and the other - cool. It is worth noting that you have to be extremely careful when breaching this procedure in plastic pipes: the metal tip of a cable may damage the integrity of the pipe.
Cleaning chemistry
Compared with previous methods, this is characterized by its ease and 100% efficiency. However, the application of industrial chemicals, you should pay attention to the specificity of the chemical, as not every agent is suitable for cast iron, steel or plastic pipes.
For a positive result you should use the instructions on the label or package insert to the facility. Most often, the manufacturer specifies the amount of water that must be filled before sleeping means, the time for which it is required to leave and the amount of water required for flushing.
Note! An important consideration when working with these substances is to comply with safety regulations. Neglected, is a recipe for nausea, allergies, rashes, and other little nice things. So before using, you need to wear mask, gloves and a hat.
Chemical agents can be used as preventive, with an estimated frequency of 1 time per month. The most popular means of cleaning include: Tiret, Tornado, Mr. Muscle and other.
Thus there are many ways to clean the pipe from clogging which method to select depends on the depth and the total weight of clogging, as well as varieties of tubes.
2017-2018. Copying of materials is possible without preliminary negotiation in the case of a direct hyperlink to our website.