As wallpaper glue in the corners without the treacherous folds?
Table of contents
- 1 Inside corners
2 Outside corners
- 2.1 furnish of slopes
- 2.2 The sequence of work
- 3 Summing up
It would be very convenient if all the rooms in the apartment were strictly smooth vertical walls, then no problem with sticking did not occur. Take it and glue vsploshnuyu, bending lines at the corners and the transition to the next wall. But the bulk of our homes built is not the best, but because not the most smooth way. And what to do if problems occur? As wallpaper glue in the corners: videos, tips and photo today in our article.
Inside cornersThis process we will meet at least four times.
- Before you glue the wallpaper in the corners, align them with a special plaster. This is the first and mandatory item of training, without which it is impossible to get a positive result.
- On one of the adjacent walls sticking strip so that it is slightly wrapped to the adjacent wall by 3-4 centimeters. Then the joint is pressed down well with a dry sponge.
- The second stage of glueing webs - gluing the strip to the second adjacent wall. Carefully measured using a tape measure or ruler point the farthest end of the strip location so that the nearest edge of 2-3 cm sign pasted on the surface.
- Check plumb contour that has been defined for bonding the far edge of the wallpaper. When it was done counting, sticking the strip to the second adjacent wall.
- Then, using a ruler and a spirit level with a knife cut through two layers of paintings at the same time. Excess, we cut from the uppermost sheet, remove.
- But narrow strip lowband remove slightly unscrewing the top. Following the end of the bent repeatedly coat with adhesive and pressed down to the surface. Junction vinyl wallpaper will turn smooth and beautiful.
Now, having understood as wallpaper paste in the corner, you can safely proceed to repair. The advantage of this method is that it can be used for both thin and heavy fabrics.
Now that you know how to glue the corners of the wallpaper - a video in this article show the process sequence.
furnish of slopes
Oddly enough, these tabs are available in many rooms and spaces. Among these are the slopes. If you are lucky, and they were smooth, you can paste over them, tightly wrapping sheet.
The sequence of work
Wallpaper glue in the corners with significant irregularities must be a small overlap.
Stuck on one wall of the strip so that the end turned onto the projection 3-4 cm.
Room with external and internal protrusions
Pressed against the edge of the surface, but are committed to ensuring that it lay flat. If these problems occur, it is possible to make some cuts. Now cut the wrapped end vertically, thus leaving only a thin edge invisible through the second web.
When using a tape measure and identify and outline the plumb line from sticking distal edge protrusion, all of this making up a second sheet sticking.
The distance from this contour to the folded edge of the first sheet to be 5-6 mm smaller bandwidth for sticking.
We should form a small overlaps.
Tip! If you kleite web on a paper basis, having a sufficient thickness, use transparent adhesive.
We hope our article has been helpful to you. In order to more accurately understand the technological and practical issues on our website provides detailed photo and video instruction, in which you will find useful information on the question.