As pokleit wallpaper whitewash (42 images): surface preparation, choice of glue, gluing process step by step

In older homes there are many difficulties in wallpapering. About how pokleit wallpaper whitewash, we describe in this article.

Are you tired of plain whitewashed walls and want to make a variety of interior room? Do you think that the repair - a very complex and long-term employment? In fact Wallpapering to whitewash only requires careful preparation of the base.

Whether it is necessary to seal whitewash?

Removal of the old finish

If you do not want to completely clean the whitewash from the wall, re-align and primed it, make sure the existing pavement.

Old whitewash must be of sufficient quality, do not have cracks and chips. On this basis, the sheets will hold well.

Of course, the risk of such a wall with wallpaper pasting also present. The use of wallpaper paste and lime may get wet peel off over time.

Portion of the substrate will fall away, and on the surface there may be bubbles.

In order to verify the reliability of the plastered surface glue one cloth as a test sample.

Ensure the quality of work and, if not whitewashing pumped up, start a full renovation.

The sequence of work

Training

primer walls

First of all, the whole plane primer coat. Do not buy cheap primer compositions, only high-quality acrylic primer deep penetration into the surface, it will help to strengthen the basis for paintings.

After completion of the drying layer, repeat the application procedure. A third anchoring layer will wallpaper glue diluted with water.

After performing all these manipulations you can safely proceed to the pasting walls.

If the wall is of poor quality whitewash, wash it using the old tulle cloth or mesh bag, the brush will also remove coating.

Wet part of the wall with warm water and allow time for the impregnation, softened whitewash easily removed with a scraper or spatula.

Choosing the glue

adhesive Application

Glue for pasting plastered walls is very important to get a good result.

• For gluing paper webs can be used all-purpose adhesive.
• Stickers for "heavy" sheets: vinyl, non-woven, fabric require a special adhesive, for example, Oscar Flezilin.
• Usually the vinyl trim and non-woven adhesive used was PVA-based, for the lighter species reconstituted wallpaper - adhesives based on methylcellulose.

Follow the instructions, spreading the adhesive dry mixture with water. Depending on the type of coating consistency varies adhesive mass and the type of application binding materials for the back side of the web, directly on the wall (nonwoven) or the simultaneous use of both options.

Attaching webs

Process of pasting walls

After training, you can begin to wallpapering.

stages:

• Rolls cut on panels considering allowance of 7-10 cm. After gluing and drying the excess can be cut with a knife for paper.
• Each sheet is thoroughly impregnated with an adhesive composition, the excess glue wiped with a damp cloth surface.

Note! Exceptions are nonwoven sheets, they do not require impregnation of glue, because the composition is applied exclusively onto the wall.

• Pasting is always performed by the window opening, strips are glued back to back, the corners - lapped.
• Each sheet roller smoothed, it allows to remove air bubbles.

Now you know how pokleit wallpaper on the lime and ready for self-repair of your apartment. In principle, this procedure is not much different from the standard wallpapering and requires only a practice which can be obtained by continuously applying the skills.

Summing up

We hope our article has been helpful to you. In order to more accurately understand the technological and practical issues on our website provides detailed photo and video instruction, in which you will find useful information on the question.

Photo Gallery