Pipes for drawing: types and installation

click fraud protection

Description of the ventilation pipe from smooth plastic

271-vent-tube-for-drawing-19509

The exhaust can be carried out through special ventilation holes in the wall, and also through the external wall directly to the street. There are situations when an appliance, the products of which must be removed, is located at a great distance from the ventilation hole or from the outer wall. It is in such cases that a vent pipe is used for drawing.

There are two types of tubing for drawing:

  • Made of flat plastic.
  • Corrugated( made of plastic or aluminum).

Each of the above types of pipes has its own characteristics and specific properties.

This type of ventilation fitting is used when the point of the intended discharge of contaminated air is far from the operating device. Such elements of the exhaust pipeline are of two types: round and square. Their difference from each other is in size and aesthetic component. Square pipes, as a rule, are not so evident in the kitchen, because they have a shape similar to furniture elements.

Air ducts made of smooth plastic have several advantages over corrugated:

  • Smooth surface eliminates the deposition of grease, dust and other combustion products on the walls.
  • Pipe products of this type minimize the occurrence of various kinds of noise effects during the drawing process.

Description of corrugated ventilation pipe

Corrugated airway valves have a number of distinctive characteristics compared to similar products made from smooth plastic:

  • Relatively low cost.
  • Flexibility, which allows to lay this type of pipe in different conditions.
  • Low complexity of installation.
  • The need for a minimum number of auxiliary elements and tools during installation.

The ventilation pipe for corrugated hoods has the following drawbacks:

  • Increasing the noise impact.
  • Possibility of heating.
  • The presence in the folds of a place for possible accumulation of deposits from dust or grease.

271-vent-tube-for-drawing-69243

Possible ways of masking airway pipes of different types

This kind of pipeline products is rather bulky and often immediately striking in view of its difference from the general structure of the interior. There are several ways to mask the airway reinforcement.

  • Hiding the elements of the pipeline using a box of wood or plasterboard. This element of the interior is easy to design under the general design structure. Important is the fact that when installing this type of device it is necessary to leave the possibility of access to the pipe in case of its failure or the need for verification.
  • Masking of pipe products using furniture. In many kitchen sets, there are special compartments for carrying out airway communications. Also, you can use conventional kitchen cabinets for camouflage after a little refinement.
  • One of the least costly and simplest ways of hiding the elements of the duct is to process the pipe itself under the tone of the interior. The ventilation pipe for drawing can be painted or decorated in accordance with the essential design of the room.

Ventilation is not a fashion statement or an answer for the sanitation service, but a direct way to improve the health of all people living or often in the building, even if this building is not associated with any type of emissions into the air( steam, dust, poisonous substances).Only a properly organized system is able to get rid of such problems, and also will not make long to mess with the editing. The article described the main characteristics and specific properties of airway communications for ventilation.

instagram viewer