Autumn has come, followed by a cold winter. Residents of private houses start to heat stoves, and are surprised to see that smoke, instead of quietly leaving the chimney, falls into a dwelling. In order not to think about how to cover the cracks in the oven, they invite a stove-maker. The newly arrived master explains that the problems are serious, and without telling how to cover the stove so that there are no cracks, exposes a round bill that scares its size. In order not to pay unreasonably inflated bills, not to wait for the master to arrive in a cold house, you need to figure out what you can do with the stove.
Contents
- Causes of smoke pollution of the
- furnace Than to cover the oven so that it does not crack?
- Crack sealing video in the
furnace. The causes of smoke from the
. The reasons why smoke does not escape through the chimney, but creep around the house, can be varied. The most common of these is a chimney clogged with soot. With the elimination of soot, heating quickly settles and there are no more problems.
If no one has lived in the house for a long time, then a putty for the oven will not be needed. The stiffened chimney starts to work incorrectly, but the malfunction is eliminated easily. It is enough to warm the riser, burning the paper, and the smoke will go the right way.
If you do not know if the stove worked before, then malfunctions in its operation can be caused by improper masonry of the chimney or blockage of channels by parts of bricks. In this case, you can not do without major repairs.
Well, and, of course, cracks in the chimney or in the furnace itself lead to disruption of its operation and the appearance of smoke in the living areas.
Than to cover the oven so that it does not crack?
Cracks in the stove - it's inevitable, but to eliminate minor problems in the state of any person.
The most common cracks that appear on heaters are cobwebs. The network, which is made up of small blind cracks, which spoil the appearance. They need to be removed, because they will gradually cover a significant surface area.
Before making a stove in the house, you need to clean the damaged area thoroughly, knock out the areas of crack formation with a chisel. The cleaned surface must be brushed over the metal. After that, the cleaned part is wetted with a primer. When the primer dries, the cleaned place is plastered with a mixture of clay and sand.
Often cracks occur in places where the elements of the stove are fastened, for example, the furnace door or ash-tray. Before coating the stove so that it does not crack, in this case it is first necessary to fully pull out the door, clean the damaged area thoroughly, only after that it is possible to begin the restoration work.
Before fixing the stove, it is necessary to fasten the wire to the frame of the door so that it does not fall out later. On the perimeter of the door you need to lay the asbestos cord, and all other work to perform the same as with the removal of cracks spiderweb.
In order to repair the cracks in the brickwork of the furnace, it is necessary first to clear the problem seams( to deepen and widen a little), then moisten with plenty of water and then cover with a thick solution of chamotte clay.
To better understand what to cover the oven, so as not to crack, we recommend you see the video at the bottom of the page.
