Stretch ceilings with your own hands

More recently, the stretch ceiling was considered a sign of the consistency of the owners of the house. Today, this is no surprise, and even an average person of wealth can afford such a "luxury".The question is not even whether there is enough money for such repairs, and the question is whether to do stretch ceilings with your own hands or to invite specialists for this?

ceiling tension installation

Removing the

ceiling If the owner of the house understands at least a bit of finishing work, the issue of installing tension ceilings with his ownhands will not be for him any problems. But in order to know how much it takes all the profiles and finishing materials, you need to take measurements from the ceiling.

This process is considered to be one of the most complex, as here it will require precision measurements. If this is not done pedantically, then the proper installation of the ceiling depends on this. Today, it is possible to mount both a single-level and a two-level stretch ceiling with their own hands - this also should immediately decide which option is preferable.

All measurements should be applied to a blank sheet of paper. First, the perimeter of the ceiling is measured and all possible diagonals are measured. This process of measurement is very important, especially when multi-level stretch ceilings are made by one's own hands, as here it is necessary to measure not only the 4 corners of the room diagonally, but all other corners as well. And only after all the measurements you can buy all the necessary materials.

Fastening profile

To make the stretch ceiling look beautiful and attractive, you need to properly fix the profile. They should be located around the perimeter of the ceiling. But before fastening them it is necessary to level the level. Also, when choosing a profile, one should take into account such a nuance: they need to be chosen so that the lamps can fit freely. When fixing, there can be only one difficulty - the angled mating of the profiles. In these places, the edge of the profile is cut at an angle of 45 degrees.

Fastening of racks for fixtures

As the device of stretch ceilings assumes also installation of fixtures it is very important to be defined with points where they will be. They need to be placed all around the perimeter of the ceiling. Together with the fixture fixtures, you should immediately make and wiring the electrical wire to them. In order to know where to cut under the lights, use the plumb bob from each luminaire to put the points of their placement on the floor, and proceed with the installation of the fabric.

Assembly of the

If you are installing a stretch ceiling with your own hands, you should know that you should warm up a little before putting it on. If this is not done, then the canvas will then sag. With the photo and video of the installation of the stretch ceiling can be found in this article. The process is shown, as well, how to do everything in order. If the ceiling is small, and besides - multi-level, then the canvas can be heated with a usual hair dryer.

If you carefully watch the video installation of the stretch ceiling, you can find out that the canvas, gradually warming up, should be fixed from the middle of the ceiling;having fixed one side, it is necessary to pass to the second. Pulling and attaching the canvas completely, it should be warmed up for about 15 minutes, - after cooling it will be well stretched. Having become acquainted with this article, you can understand how to make stretch ceilings with your own hands, even in an apartment, even in a private house.

Ceiling tension installation video with your own hands

Ceiling suspended ceiling with pipe: