Usage and function of the
electric splitter It is intended for selection of wood for rectangular sockets for the purpose of fixing parts. The main part of this tool - consisting of small, hinged, cutters chisel chain. To obtain nests of various sizes, you only need to change the plate on which the grooving chain is attached. To ensure that the edges of the attachment socket are even, before starting work, you need to clean or sharpen the incisors, then you can prepare the machine for work. The next step is the use of an electrodevice-fixing a part or board on a workbench, installing a machine on it and turning it on.
Before starting to work, the workpiece or bar is fixed in a vice and a simple hard pencil is applied to the marking on the surface of the wood, after which the knives are made with risks. If the hole should be large and deep, first of all you should select the wood with a chisel and only then chamfer the surface with a chisel. Before starting work, you need to pay attention to the selection of wood near the edges of the edges of the edges.
Large blind holes are made as follows: using a kayak drive the blade of the bit, then slightly incline to the opposite edge with a chamfered side and lift the canvas up. Break the wood and separate a few pieces from the array. Then, for 2-3 mm, they retreat from the hole made and repeat everything. It is important to remember that when finishing the edge of the groove every 1 to 2 mm away from it, and the chisel is chamfered to it. In the case where it is possible to lift the canvas of the bit by the side where the chamfer is removed, it is necessary to lift the wood with an unprotected surface of the blade.
If necessary, make a through hole, the wood sample should be made simultaneously from both sides, gradually reducing the intermediate layer. Then the edges of the hole are straightened with a narrow chisel. It is very important to observe a number of precautions when working with an electric solder. These include, in particular, ensuring the electrical wiring is in order, the correct attachment of the grooving chain, the correct supply of wood when using a fixed machine. In the event that the machine is not fixed, it is necessary to ensure reliable fastening of the bar. You can not start work with an ungrounded machine - this is your safety first.
Repair of the apartment with your own hands for free. Thank you for attention.
