5 important life hacking laying tile + step by step guide

If you come to laying ceramic tiles with full responsibility and forethought, you can not only greatly simplify your life, but also save a good amount on repairs. In each case there are subtleties that help simplify the process of doing work. Laying ceramic is no exception. Here are a few secrets installation of tile, which will help you save time and effort.

Advance preparation - this is important

Some newcomers to repair really believe that the most important thing - it is the process itself. Training is not as important as just laying tile. This is a huge misconception. A well-prepared surface - it 50%success.

To start prostuchite entire surface if you found voids or bundles - refurbish them. The walls are best dub beaconsBecause in the future it will significantly facilitate the process of lining and coating of glue.

Once all surfaces are aligned, move to primer. Be sure to use soil solution deep penetrationThis will help to make a more solid base.

Before laying the tiles must also be

apply sealant at the joints between the boards and the bathroom (if the repair is done in the bathroom), and between the boards and the sink (if the repair is done in the kitchen).

Stacking order - step by step guide

For those who are renovating a bathroom, the task is simplified. You can immediately go to the bath level. This is the best option. In addition, the seam in this case will be more aesthetically pleasing and moisture-resistant, as a side bathroom is a little care of a tile, a seam between them will be sealed and covered with a trowel.

Step 1. Will be coated with the volume, which is located above the rim-mounted bath and profile. If the ceiling in the room hanging, then you need to think in advance where it will be placed to mark the installation of a plastic profile or baguette.

Step 2. Lay the remaining volume (i.e. the volume under the profile).

Step 3. Fit the metal frame, which you will need to assemble the screen under the bath. Take care that the whole structure was static and there was no backlash.

Step 4. Then clean the floor surface, dirt, apply the solution and place on the floor tile already.

secrets laying

Laying ceramic - is a topic that requires a separate article. Here we say that she suffers haste and carelessness.

Mix the tile adhesive via-mixer nozzle. Leave the solution stand for a while, then re-mix and apply it with a notched trowel to the rear surface of the ceramic piece.

Note: to ensure maximum coupling ceramics, apply a thin layer of a solution "to tearing." This, of course, will reduce the rate of laying, but increase the grip (though significant).

Once the adhesive mixture was applied to a tile is pressed ceramic segment to the wall, making thus a small movement to the left and right in order to smooth the layer of adhesive and prevent voids formed. Try a number of stacked tiles of one package, so more likely that the difference in size will not be too noticeable.

Breaking tiles exactly

If you need a break tile segment and at the same time you are afraid that tiles crumble, ceramics soak in water for 45 minutes to 1 hour. Next, take the roller glass cutter and cut them to segments. When you align the section line on a piece of tile from the edge of the table, in which case the fracture line is perfectly straight, and you do not have to dub it manually.

Repair tile floor

Not necessarily to dismantle the ceramic floor, if the time from the total figure has dropped a few fragments., A simple repair.

The reverse of the ceramic segment and the hole in which it is located, you need to thoroughly clean of debris and dust. Do not scrub out the grout! Apply the recess from the tile itself and tiles adhesive solution (can take BP-2 and BP-6). It is best to do this a couple of times a procedure, each time giving Adhesive to dry completely. 3-4 times Lay the ceramics in the opening and press down on the load 24-48 hours.