Malfunction of the refrigerator and repair their own hands, if it flows

Refrigerators modern type are very reliable, so the damage and failure is very rare. The main cause of failure is trivial voltage drop in the network or rough handling of the unit. Then appliances stop behaving the usual way, but the panic in this case is not worth it. Simple fault, when the refrigerator is not included, it is easy to fix at home: it is enough just to deal with the mechanism, the cause of such damage and to take urgent action.

The normalization of the working condition of the equipment

To household appliances behave quite adequately, produce the following:

1. Measure the voltage stabilizer, with the standard index - 220 watts.
2. Correctly set the temperature, turn the knob to the desired position if necessary.
3. Check the perfect seal of the door.
4. Examine the freezer for ice.

It is important that any failure of the refrigerator, associated with abuse and requires close attention. Cooling equipment is connected only to a particular outlet and the defrost process does not permit the use of sharp objects.

Typical damage refrigerator

A situation where the refrigerator is not switched on, a very common. The reason for this failure should be sought in the power cord or the thermostat. Check the state of these elements can be visually view or remove terminals and subsequent closure of the two wires. If these measures do not help to restore the operation of the equipment, replace the regulator.

Note that the normal functioning of the studied reveal violations in the motor work.

Other causes of breakage of the refrigerator (not included):

• in the absence of mains voltage;
• unplugged;
• faulty fuse;
• improper wiring connections.

When the appliance is not turned off, the problem lies in the following:

• The door is not closed properly.
• Is set to a strong freezing or quick setback: when manual mode this function is turned off.
• Excessively high temperature in the room causes the refrigerator to operate in a continuous mode, and you can correct the situation, chill room.

Attention! This situation is dangerous because the continuous work cycle causes overheating and rapid wear of the equipment.

visible leaks

Also flows refrigerator for several reasons. To begin, check the junction of drain tubes for the presence of their integrity. Such trouble comes from an excess of water in the tank for drainage or its displacement. It is possible that the vessel could break. Of course, the replacement of equipment makes the master, otherwise possible refrigerator repair their own hands.

The reason for this failure may lie in the wrong location of products in the department when they are very close to the evaporator. Remedy the situation will help ordinary shifting victuals.

Refrigerator flows and due to clogging of the drain pipe: to solve it usually clears syringe and well washed. This phenomenon is observed at the time of a power outage that caused the thaw. What to do in this case? Wait for complete defrosting the refrigerator, wash and wipe it, then carefully dried. One circumstance in which the flows on the rear wall of the refrigerator, it is quite normal, because the correct operation of equipment associated with the action of the mechanism. Fluid flows into the drainage flow to cool the unit.

Attention to the door seal

If the refrigerator door is closed tightly, we can repair the refrigerator with their own hands, just adjust it. Unresolved problem is the reason for calling the master.

Sometimes the seals there is visible damage or signs of wear. Then the warm air gets into the camera, preventing it from gaining the desired temperature.

In some cases it is necessary to reinstall the entire door, but also some gum for a refrigerator can be replaced. The fastening member is under seal, unscrew it very easily. A new gasket may be in the form of the letter "G", which is cut to the size of the door and connect the corners of the rectangular pad. For reliability, is additionally used glue.

Problems with interior lighting

Light bulb in the refrigerator allows a good view of its contents. If it does not light up when you open the door, you can repeatedly press the switch. If it is OK, the problem should be sought in the light bulb.

How to replace:

• De-energize the device.
• Unscrew the cover, sliding it slightly to the side or by tapping on the hull. Latches should be free to withdraw from them. With old equipment need to be very careful, such ceiling is easy to crack.
• Screw in a new bulb, immediately check its performance.
• Put all the parts into place and plug in the power.

old-style refrigerator, running for decades, accumulate a large amount of fat that often cause clogging of the cartridge. In this case, the light bulb spun, eliminate pollution, providing easy access to the terminals.

How to adjust the temperature in the refrigerator?

The bulk of perishable products are stored at +2, +5 degrees. If the thermometer is faulty refrigerator food easy to freeze. Excessive heat in the office leads to the growth of bacteria, resulting in fruits and vegetables rot, moldy sausage and drinks turn sour. Frozen products still harder to tolerate temperatures jump. Broken thermometer for a refrigerator in the intensive freezing in a short period of time will spoil all the products, making them unsuitable for food mass.

To properly set the temperature in the unit, you can get data from the instruction. Thermometer for refrigerator ensures the safety of the products at 1, 5 degrees. Values ​​may be any in the freezer: -18 and -20 degrees is good enough for storage of meat, fish, vegetables.

Strict adherence to the rules of operation will extend the use of the equipment and will prevent unnecessary problems. A typical fault described refrigerator will help the average person understand the problem of breakage and learn the wisdom of a simple repair.