Creates laminate floor - find out the causes of
Before you remove the creaking of the laminate, you need to find out the cause of this unpleasant sound. In total, there can usually be three:
- Sand or debris under the floor covering. This reason is most common for this type of coating. Thus, during the movement through the rooms, the tenant hears a very characteristic sound, which is called scratching the laminate. To designate the appearance of such a defect, there can only be one thing: during the laying, the surface was forgotten to be vacuumed or even not cleaned at all. If you used high-quality laminate, then it makes sense to suffer a bit, until the grains of sand are removed and creaks cease.
Warning! If the laminate is of poor quality, then the sand, having got into the locks, completely damages them for a year or less, which leads to the failure of the floor covering! And this, in turn, to additional financial costs.
- The second reason why the laminate crunches is the lack of a gap between the floor surface and the skirting board .According to the installation rules, the decorative strip must be suspended above the surface of the laminate, which will give it a place to move. If there is no such, then the friction of these two elements will create unpleasant sounds during the movements.
Tip! To once again be safe from the appearance of scratches, it is necessary to leave a gap of 1 cm between the wall and the laminate, but not less!
- Few people know that after complete installation of the floor covering presented, it takes some time, so to speak, to replace it. For this reason, he needs a place for this. Since the material is made of wood, it reacts very sensitively to temperature changes. So, if he does not have a place to move, then, resting on the wall, in certain places the covering will rise. Coming to such a place, you will hear characteristic sounds.
- The third reason is the uneven floor. This is the grossest mistake that can be tolerated while laying.
Remember! If there are depressions or protrusions on the floor surface, then they must be eliminated!
- Even if you lay several layers under the floor covering, they will either erase over time, or they will ask, which will lead to the appearance of creaks.
Solving problems on your own
If you have a question: "Creates a laminate floor, what should I do?", This chapter will help you to understand it. Immediately say that nothing pleasant in the process of eliminating defects is not. But, as they say, you can not do anything! So, let's consider the main points:
The easiest task for you is if there is no gap between the baseboard and the floor covering. In this case, you need to dismantle the plinth. After that, having exposed the necessary backlash, to establish it on a wall.
Warning! After removing the plinth, pay attention to the existing gap between the wall and the laminate. If there is not enough, then it's worth cutting the board along.
The worst option is if you notice that the floor is uneven, which causes unpleasant sounds. In this case, you will have to dismantle the entire surface with its subsequent alignment with special mixtures. After that, you will need to re-install the laminate.
Less time consuming is the process of eliminating creaks due to dust falling under the cover. You will also have to remove the entire floor, but just clean it properly. After that, lay the laminate again. In addition, do not forget to put each plate apart, because dust and sand, for sure, hit them!
expert advice The professionals of your business share some tips that will help quickly and efficiently eliminate unpleasant sounds when walking on a laminate. So, if you find the place where the cover produces a characteristic sound, you need to remove the plaques and put a piece of cardboard under them. This will help to soften the swing of the cover and eliminate the creaks.
Another expert advice is that for high-quality installation of the coating, only the masters should be contacted. Some citizens, after reading the instructions, believe that laying the laminate - it's a bleak business. In principle, it is. But in order to avoid further elimination of defects, you need to carefully prepare the surface. And many people do not cope with this task!