Most summer residents have long perceived their "hacienda" not as a means of hard labor and survival, but as an opportunity to relax after a difficult work week. Hot summer and the need for water procedures prompts you to build a swimming pool with your own hands, which will be a wonderful budget option for a good rest.
Contents
- Construction stages
- Instruction for the construction of a swimming pool in the country house
- Video of building a swimming pool with your own hands
Before you start building a swimming pool with your own hands, practice building a small decorative pond or fountain in a recreation area, then grab a full sized pond.
Construction stages
The variety of modern technologies allows us to apply a wide variety of construction methods, which differ in complexity and cost. Today, the traditional method of creating a monolithic bowl with removable formwork will be considered.
The main stages of the construction of a dacha pool with their own hands will always be similar, here are the main ones:
- planning and drawing of the future design;
- drainage and thermal insulation of the reservoir;
- reinforcement of the bowl;
- wiring;
- directly pouring solution;
- sealing and final finishing.
Instructions for the construction of the pool at the dacha
You were going to build a mini-pool with your own hands of concrete or a full body of water, the preparatory work will be the same. First it is necessary to take the plan of the estate and determine the place where the future pool will be located. It is desirable that there are no trees close.
In the open space, water will warm up better, foliage will not clog water, and roots will not damage the integrity of the bowl.
Please note that for free swimming an adult will need a pool depth of at least one and a half meters. It should be noted that about fifty centimeters will go to drainage and wall thickness. Before digging a foundation ditch in a holiday village, it is necessary to draw up a plan for the distribution of communications and then begin work. To ensure that its walls do not crumble, it is recommended to make a gradient of five degrees.
The creation of a waterproofing layer begins with the arrangement of a pillow consisting of 15 centimeters of sand and 15 centimeters of rubble. After this, two layers of roofing material are laid to enhance the waterproofing properties of the pool. The edges of the roofing material must lie on the inner walls of the foundation pit no less than 20 centimeters.
Reinforcement of the bottom of the bowl is the creation of a frame of reinforcement A3 and a diameter of 12 mm. After this you can start concreting. Ideally, you need to fill the entire cup at the same time. In reality, it is extremely difficult to achieve this, especially not to a professional.
Therefore, the work will be carried out in stages: first the bottom, then the walls. The bottom does not need to be made perfectly even. A slight slope of about 2 degrees is required in the direction of draining.
In order for the screed to be of high quality, it is necessary to use vibration compactors, which will allow to obtain products of higher quality. While the solution, flooded to the bottom, freezes, you can do the laying of communications.
When the bottom is ready, we create a formwork for the walls. Its width should not be less than 40 centimeters. We equip the frame from the reinforcement and connect it to the horizontal frame. After that, we make the same robots, as well as filling the bottom. After the solution has solidified, you can proceed to the final finish of the pool bowl.
Looking constantly at our website, you can not only view photos and videos of how to make a pool in the country with your own hands, but also many other useful works, as well as get answers from experts regarding repairs and construction.
