Space saving and aesthetic features are the main advantages of a suspended toilet bowl, therefore, stopping at the choice of this option, its owner certainly will not lose. If special issues do not arise with the installation of the toilet, then its hanging "colleague" will require sleight of hand because of the presence of an additional link in the bathroom - the installation. The installation of the toilet installation by one's own hands does not involve complexity if you have all the necessary construction tools and perform the work in stages.
Contents
- Preparatory stage
- Installing the installation of the
- suspended toilet Toilet video installation of the toilet
The trouble-free operation of the sanitary ware depends on the sequence of installation of the toilet installation. First of all, its installation itself is made, then the connection of sewerage, camouflage of visible elements and finishing. For clarity, the photos and videos of the installation for the toilet are shown below, which will greatly simplify the perception of information.
Preparatory stage
First of all, together with the toilet it is necessary to purchase the installation system. Unlike the bidet, today the market offers a wide selection of their manufacturers. By their principle, they all represent a flush-mounted frame. But here, as they say, to each his own.
Tools require a perforator or drill, a drill bit for concrete with a diameter of a fastener hole, wrenches, a building level, a pencil and a tape measure.
When all necessary construction equipment is at hand, we begin to perform marking and preparation of the fastener system. It is important to measure the gap from the installation system to the surface of the wall and mark the point of the drain tank. It will be correctly installed at a height of 100 cm from the floor.
We do not forget about the fastening of the installation itself: it's necessary to mark the points for fastening elements on the surface of the wall and floor. In this case, fasteners should pay special attention. With the help of a drill hole holes are drilled on the previously made marks, where anchors with dowels are inserted.
Installing the installation of the
hanging toilet bowl The installation scheme for the toilet bowl installation has a clear sequence:
- , a frame is erected at a pre-arranged place, which is fixed with special adjusting nuts and screws;
- , the installation casing is adjusted horizontally and vertically;The
- horizontal level is set by adjusting the structure of the legs, and the vertical level by fitting the anchor thread.
After making installation of the installation for the toilet, it is necessary to bring the toilet to the sewer pipe. It was important to establish in advance a branch pipe with a diameter of 110 mm and a water supply.
Regarding the supply of water to the tank, experts recommend using a rigid pipe instead of flexible piping. Pipes from the drain tank and sewer pipe are fixed to the fixing plastic clamps.
Finally, before installing the sanitary ware, we again check the tightening of all the elements. Finally, we put on the PVC couplings, install the cushioning gasket and the bowl of the toilet bowl.
Installation under the toilet is not an aesthetic attribute of the bathroom. To bring it to its logical end, it is necessary to sew the installation system and finish the material, which will complement the design as much as possible and give the necessary comfort. Experts advise to use a double moisture resistant gypsum board, and as a finish - tile.
Video of installation of installation of a toilet bow with own hands
Schematic video from company Geberit:
