Construction of the foundation
If you are interested in how to build a bath from a foam block for a finished project, then keep in mind - you need to start from the foundation. Here act as follows:
- Dig a trench;
- At the corners of the pit, with the help of a laser level, pins are placed;
- Through the entire length of the future foundation, intermediate pins are driven in( the distance between them should be about 2 m);
- Assemble a special frame from the armature;
- Install the formwork, lay a layer of insulation and pour concrete;
- After drying concrete lay sewer pipes.
This is one of the most important stages of construction, and a person who is interested in how to build a bath of foam blocks should approach his organization as responsibly as possible. After all, a lot depends on the quality of execution and the strength of the foundation.
How to build and insulate the walls of baths from the foam block
The next stage is the erection of the walls of the structure. And by this time the cement should already be completely frozen. Proceed according to the scheme:
Waterproofing of walls.
For this purpose it is expedient to use bitumen and roofing material. With thermal insulation materials, be careful - it's not for nothing that experts advise a person who is interested in how to insulate a bath of foam blocks, take a very serious approach to choosing heaters. They must be vapor-permeable, non-flammable, environmentally friendly and resistant to multiplication of fungi and bacteria.
Stack of pre-selected blocks.
The foam blocks must be placed on the edge, carefully following the thickness of the joints( it should be small).Also, do not forget that experts recommend using a special masonry net during the installation process.
Subtlety of erecting the roof
Very seriously, a person who is interested in how to make a bath of foam blocks should go to the device of its roof. Its main element will be Mauerla, made of boards, the size of which is 15x5 cm. As for rafters, for them it is recommended to use boards measuring 10x4 cm, and the distance between rafters should be 1.02 m.
It is also important to design a crate -boards size 10x2.5 cm, which are set at a distance of 50 cm from each other. And of course, in the process of installing the roof must necessarily be made a rough floor and a black ceiling of the attic. And the rough ceiling is recommended to be insulated with polystyrene foam. And to cope with the performance of all these works can any consumer - it is important only in all the nuances to understand how to build a bath of foam blocks from the foundation to the roof and master certain skills.
Interior decoration of the building
Of course, it is impossible not to note that the bath with foam blocks with their own hands is not only external but also interior decoration. In particular, a stove must be installed in the steam room. And it is also important to properly install doors and windows, make decorative wall, ceiling and floor finishes, arrange ventilation, etc. Moreover, all these works should be carried out at the highest quality level and always in compliance with safety rules.