Good day. In general, an amplifier was purchased for the car. I put it in storage in the stoker, but in the accident, the stoker was flooded and the amplifier was submerged in water for at least half, and lay there from 1 to 2 hours, as soon as I discovered this, I immediately pulled it out, took it out of the package, put it in a vertical position, so that the water glass, after 20 minutes, rubbed it externally, and put it in a wooden box (from the same amplifier, they are in boxes supplied). Rice was previously sprinkled on the bottom of the box, where it lay for about 30 hours.
Question: should I disassemble it (violating the warranty) in order to wipe the entire board and all contacts with alcohol? And will it work at all after that? Without any power loss? And also 1 car subwoofer was flooded, it was on the coil (in the box), but unfortunately I could not put it in the rice (over). From the subwoofer there was only a magnet in the water (50-60 mm high) at the bottom of the magnetic system there are ventilation holes. When I took it out, water also flowed out from there, could something happen to it? I put it on drying at an angle of 45 degrees, in a warm room.
(0)I do not like
(0)