Before starting work
In order to begin the process of cleaning the surfaces of the room from soot stains, it is necessary to acquire a certain number of cleaning tools and detergents:
- Broom and brush.
- Rags.
- A cleaner for washing various surfaces.
- A product of white spirit.
- Primer.
Step-by-step instruction for performing the work
The work on removing soot stains from the surfaces of the apartment consists of several step-by-step activities:
- Determination of the spatial directions in which the work will be done.
- Pre-purification.
- Preparation of special cleaning tools for work.
- Preparation of a room for wet cleaning.
- The final stage of wet cleaning.
- Additional cleansing of fatty particles.
- Priming.
Performing the work of
Step 1. Determination of the spatial directions by which the work will be done. Spots of soot should be cleaned from top to bottom to avoid additional contamination.
Step 2. Pre-purification. Before starting cleaning, the place of work should be covered with old newspapers or other materials that will not be a pity to throw out. Then it is necessary to perform preliminary cleaning with a vacuum cleaner or broom. When working with a broom should not be carefully and with the pressure to remove soot, and clean it with sharp movements.
Step 3. Preparation of special cleaning tools for work. In modern hardware stores you can buy rags or sponges, designed specifically for cleaning soot. They are the usual purchased materials for cleaning, but additionally impregnated with chemical composition. Work with such materials is gradual, removing soot strip after band. The soiled surface should not be washed off, but cut off with layers using a razor or a mounting knife.
Step 4: Prepare a room for wet cleaning. After preliminary cleaning and cleaning with the help of special materials it is necessary to clean newspapers with garbage. Before wet cleaning, the floor should be covered with polyethylene materials. Then prepare the cleaning solution with a degreaser. Then prepare a large number of rags for cleaning.
Step 5. The final stage of wet cleaning. After the wall or ceiling is dry, you need to make sure whether you need an additional cleaning. If it is not needed, the surface must be cleaned once more with clean, warm water. In the presence of small spots it is necessary to treat them with a tampon impregnated with white spirit.
Step 6. Additional cleaning of fatty particles. After all the performed manipulations, it is worthwhile to once again inspect the surface of the walls and ceiling for the appearance of repeated appearance of greasy spots.
Step 7. Priming. After carrying out all the above-described work, it is worth giving the surface a dry, and then again check for spots. If the degree of purification is sufficient, then it is possible to apply a primer. To do this, it is best to use a primer with hermetic properties.
Thus, the article described and characterized the process of cleaning the surfaces of the apartment from soot stains.
