Highlights Installation drawing in the house: step by step guide self-assembly

Extractor hood - an indispensable device for purification of air from outside odor, small droplets of fat and the compounds of the resultant combustion gas. It is proved that the extract in the house helps to normalize microclimate and ensure optimal ventilation.

Steps for Installing the exhaust system

installation process is simple, if you follow our instructions, the installation will not take much time. The sequence of actions is as follows.

preparation tools

For work you need the following tools:

• Level;
• Ruler and pencil;
• Depending on the type of wall: drill or screwdriver;
• A set of screwdrivers and keys;
• Tools for processing cabinet or plastic boxes: jig saw, sandpaper, handsaw.

Mounting the exhaust system

There are two versions of the hood: a wall and built in wardrobe. Methods of installing such systems have differences. Consider each embodiment separately.

Installation wall model

the following steps need to consistently perform:

1. With the help of an adhesive tape is attached to the wall template. This is done in such a way that it coincides with the previously you applied markings on the wall.
2. We do the perforator via hole diameter or drill 1 cm - a classic (diameter required in each case is indicated in the instructions). Hole depth should be 5 cm.
3. Disconnect from the wall template. In the knockout holes put dowels 1 cm.
4. Screws are screwed so that a gap remains for hanging the main structure.
5. With hoods remove filters. On the inside of the holes you need to feel like locks, and they set the hood.
6. We fix filters.

If the exhaust system you need only to circulating operation, then this installation is complete.

Install built-hood

the following steps need to consistently perform:

1. Make sure that the cabinet is level over the stove.
2. Disconnect the bottom wall of the cabinet. On a shelf, which is planned to connect the hood, fasten the template.
3. Use a pencil apply labels for future openings. All they need 4 pieces - they are located in different corners, just one big hole for air.
4. Use the drawing tools Draw perfect circle.
5. Next, using a drill, fasten drill 0.5 cm. and a hole is drilled in the previously identified areas. They will be installed with screws. Take the jigsaw and make holes for the duct.
6. Is attached to the special adapter to connect the system to an exhaust duct or pipe.
7. Fasten a shelf to the hood, with the proviso that the cabinet of small size, then set module. The major variants of cabinets, you must first install the lower part, and only then carry out the installation of the hood.
8. Set the cabinet to the wall.

After that, we can only build in filters.

Duct connection - step by step guide

The main purpose of this part of the exhaust system is in the combustion products and fumes. One side of it is attached to the adapter hood, the second - with the place, diverting airflow from home. The procedure itself does not represent anything complex, you will need to make some calculations, and an overall design scheme. It is necessary to take into account one thing: it is not necessary to block the hole too tightly, as this will lead to disruption of normal ventilation in the room.

There are two ways to ensure an optimal supply and exhaust air exchange:

Step 1. Install the grille, which will have an additional hole for securing the exhaust system. Thus room ventilation level is not changed.

Step 2. Accommodate special valve, with which you can adjust the airflow.

Connection to the mains

To connect the appliance to the network, it is sufficient to have one socket. Usually it is at the level of the hood, left or right of it. If a number is not available outlet, you need to call a specialist in electrical and trust him to work on the device more elektrotochki.

As you can see, there is nothing difficult if you follow our instructions and precautions to install exhaust equipment.