As his hands quickly to repair the damaged section of linoleum - step by step guide

Linoleum - the most popular floor coverings in our country. At the same time it has a substantial disadvantage - low strength. Get linoleum can damage both at the stage of his favorites, and directly during operation.

There are many types of damage and depending on the specific situation you need to use a specific method of repair. In this article we describe in detail about how to repair damaged linoleum.

What to do if linoleum seasoned web

The first step is to pick up a piece of material with the same pattern as on the damaged portion of the coating. Is how easy is to eliminate the defect, it affects the degree of the burn. A small spark destroys the tread and decorative layers, or only one of them. Very rarely causes damage to the base layer. the following steps need to be taken at:

• Burning the outer layer. Remains of burning doctoring solid metal object, the top cover with a transparent varnish or mastic.
• Burn the decorative part. Apply cold welding in order to glue a piece of material with the same pattern. In the absence of such, cut from a little under the plinth. Part C layer linoleum remove crumbs and fix the active moiety at the site of the damaged portion of the material using an adhesive.

The patch is set as follows:

• Cut a piece of new material is slightly wider than the existing damaged area.
• Completely clean the space that will be applied our patch.
• Raise the edge of the base.
• Apply glue to the patch, install it on the damaged area. We put on top of a heavy object.

Likewise carried repairing torn holes. After pochinochnye work is finished, save the remaining materials - most likely they will be useful to you next time.

What to do if pinholes and dents on linoleum

In case of detection of such defects it is desirable to eliminate as soon as possible. After all, with wet cleaning for floor covering can get debris and moisture that can cause swelling and mold development.

In order to get rid of pinholes and dents is necessary to cover the place in which they appeared, putty and smooth it with a trowel. Next, use the wax to wipe the surface.

Plaster contains the following components:

1. Alcohol — 5 parts.
2. The oil of castor oil — 5 parts.
3. Rosin — 20 parts.

What to do if compromise the integrity of connecting seams - step by step guide

Not tight places need to fluff glue. Method cold welding for this ideal. Because of its special composition, the adhesive, when applied on joints, slightly dissolves the edges, and then connects them firmly. In this process, the material layers merge with one another at 2-6 mm.

A phased plan of work in the performance of cold welding:

Step 1.We put two parts material on each other, overlap, approximately 5 cm.

Step 2. Centered overlay place linoleum Draw a line.

Step 3.cut knife on the marked line. To cut comfortably, beneath the linoleum steel plate.

Step 4. Cut pieces can be thrown out. at the junction fasten masking tape and a knife cuts through it at the place of contact between two pieces of material.

Step5. For applying adhesive use a special gun with a fine tip, they fill the joint. Across 20-35 minutes you can disconnect the tape. He is, in this case, serves as a protecting agent.

hot welding It is carried out using column whose temperature is increased by means of the dryer construction. The sequence of actions is as follows:

1. Increases the distance between the joints to 5-6 mm.
2. Heat up cord until until it becomes pliable.
3. Before it gets cold, We laid on the seam. Due to the increased temperature, the vulcanization of the edges of linoleum.

This method is considered to be more efficient, but requires a greater awareness in matters of treatment of construction equipment.

In carrying out the above instructions to repair damaged linoleum not be easy. Most importantly, when the repair, do not rush and carefully calculate their actions, so as not to damage the entire areas.