LED lamps for the ceiling - select and install, simple assembly instruction

Successful lighting in the room - the key to the successful completion of repair. Today luminaires designed not only to illuminate the room but also in order to emphasize the dignity of the interiors. The use of traditional incandescent light bulbs has long been overdue: modern LED lighting means to illuminate the room area is much brighter, while saving costs electricity at times.

How to choose LED lamp for the ceiling and install them correctly - on.

LED lamps: the variety and selection rules

lighting equipment range offers a wide choice of options.

The different ice-lamps:

area setting. Lighting various classifications can be used to illuminate a room or a separate interior. Shared devices on the ceiling, wall and furniture.
Areas of use. Ice fixtures come home and office, street and landscape, decorative and architectural, as well as industrial and emergency response.
additional functionality. Some models of luminaires can be equipped with a remote control or a motion sensor.
design differences. Form Factor lamp can be overlaid, line, embedded and external.

destination. On sale you can find lamps for use in different rooms: living room lamps for lighting fixtures for the kitchen, etc.
shape. Can meet triangular, square, round lamps and the traditional rectangular models.

Lamp equipped with one or more LEDs. When selecting fixtures is important to consider their power. For example, the brightness of an incandescent lamp with a power 80 W can be compared with LED equipment consumes only 12 W. To ensure the same brightness require less powerful ice-lamps.

Key selection criteria:

Power lamps and a radiator. For example, vinyl ceilings better protect from possible heating lamps and choose the necessary low-power lamps. From radiator quality will depend on the degree of heating of the fixture. Overheating ice-lamp often fails.
Type of housing and its size and the method of installation models: recessed luminaire or surface. Provided the luminaire on existing ceiling, keep in mind that between the trim ceiling and floor slab was space to take stock of the wiring and installation of built model. In the case of the overhaul of the ceiling on this parameter can be ignored, and customized surface under the existing fixtures.
Low light flux. For example, there are lamps with warm yellow fluorescent, cold flow blue and other hues.

Also, when buying bulbs pay attention to the basement, especially for low-cost lighting products little-known firms. Better to buy lamps with common type of cap.

Step by step installation guide

The process of mounting the LED lamp on the ceiling can differ drastically depending on the type of the device itself. Consider the step by step instructions for installing the most commonly used ice-lamps - Embedded spotlight.

Set such lamps in suspended ceiling structures and provide a number of conditions which must necessarily be observed even at the design stage:

electrical supply to the installation site;
protect electric wires special flexi hose;
presence of the holes of the correct size for the installation of devices.

If these conditions are not met, carry out installation will be a bit more complicated.

Step 1. When using a drill with a circular nozzle done in the false ceiling of the desired hole diameter. Holes are needed only in the field installation of spotlights.

Step 2. If possible - dismantle part of the ceiling of the wall, which will be produced by the supply wiring. If the integrity of the design - it neatly done in the hole.

Step 3. Prepare wiring (Measure out the desired wire, their number and the plant in the corrugations). Before laying cables under the ceiling trim, check the system performance.

step 4. Now it is necessary to make the electric wire made aperture and to withdraw to the installation of lighting fixtures.

Some installers use for this pocket of trained dogs that can move freely inside design, but these pets do not have everything, so you can limit the length of a rigid rod with a magnet or a hook on end.