Plastic slopes with your own hands

click fraud protection

Installation of plastic slopes

The installation of plastic slopes with their own hands begins with a thorough clearing of the window openings, where the remnants of old slopes are eliminated. It is necessary to carry out plastic slopes with your own hands very carefully so that the remains do not damage the glass unit and do not scratch the plastic.

Next, you need to trim the mounting foam from the protruding seam, and then start working on the frame. As its fastening, it is necessary to use galvanized hole plates, that is, a direct suspension, which is used when working with gypsum board. The frame must be made of wood, which must be treated in advance with special antifungal and hydrophobic compounds.

Plastic slopes with your own hands

A tree is used because it has a lower thermal conductivity than a metal profile, and it is very convenient to work with it, you can do it yourself. The tree is very easy to process, and the plastic is attached to it using a stapler, the screws are screwed with a standard screwdriver.

Plastic slopes with their own hands

Next to the wall with the help of self-tapping plastic plates, and you can also use dowels 2-3 cm long and with a diameter of 6 mm. Then, with the help of self-tapping screws, first, on one side, and then on the other. With the help of self-tapping screws with a press washer or stapler, the plastic guides are fixed. Then it is necessary to adjust the size of the plastic strip and insert it into the grooves of the profile.

It is worth noting that in the transverse arrangement of the plastic lining its last panel is adjusted so that when the slope is full, the lining does not go into the profile by 3-5 mm, where it can move inwards 7-9 mm. After this, you need to insert all the plates to fill the slope, except the penultimate and last. Next, you need to insert the last plate and push it all the way so that it goes into the profile.

At the last stage, you need to insert the penultimate plate, slightly pushing the last plate, then you need to close the gap between them.

That's all the operations that help make plastic slopes with your own hands. Also, they can be insulated with a moisture-resistant insulation, filling it with a void under the panels.

instagram viewer