Well or well: what is better for giving and home, a difference from the water pipe, on the site what are the waters

click fraud protection

The well is a unique hydraulic engineering structure. Recently, there are also used wells The well is a unique hydraulic engineering structure. Recently, wells are also used here. There is not enough evaluation from the category of "cheap / expensive", there are situations when only one option is allowed, the second one is near this house well, you can not do it. It is not worth worrying about, just consider all the selection criteria, determined with what is acceptable specifically for your dacha.

Contents:
    • Issue No. 1: Well or well that is better for giving
    • Species: what are the wells
    • What is better: the difference of the well from the well
    • How to make a well in the well
    • Well or well- that is more practical( video)

Question number 1: well or well, which is better for giving

You need to start with concepts. What is a well?It is a deep and narrow pit. Which is meant for water intake, and the bottom of this pit rests on the aquifer. This is the oldest way to get water. And what is a well is the development of a special circular section in the ground, it is also intended for water intake. It is believed that this method differs by a more technological method of organizing private water supply.

The well is a vertical groove with reinforced walls and a lifting mechanism The well is a vertical groove with reinforced walls and a lifting mechanism

What to choose is not only based on the criterion of novelty. For example, a well - this method has many advantages, to this day it is extremely in demand.

Water well:

  • It consists of three elements - namely, the head, shaft and water intake. The head is called what protrudes above the surface of the well. Mine is the trunk.
  • The depth of the well will depend on where the aquifer is located, and on its debit. A debit is the amount of water that enters the well for a certain amount of time. The depth of the well can reach 10-16 m.
  • Most often, the well is digging by hand, after which the ground is removed, and the walls of the resulting shaft are reinforced with standard concrete rings. It is also possible to use a piece of finishing material such as stone or brick, and wood( larch, oak, pine) is also used.

And here are the arguments in favor of the well: it is relatively cheap to dig it out on the site, everything can be done without other involvement of specialists. Also important is the continuous supply of water, water is supplied manually, even if there is no electricity. Finally, it's easy to take care of how to use it, too, perhaps, everyone knows.

Types: what are the wells

In the main classification of wells the following types: key, shaft, tubular. If to classify according to the soil, then the following types of wells are distinguished: on peat, on sand, on clay. The best are wells on clay soil, this is speaking about the quality of water. After all, it passes multilevel filtering. Negative on the quality of water affects only clay quicksand.

At first glance, digging a well with your own hands seems a rather complicated process, but if you follow all the rules, then you can easily dig a well with your own hands At first glance, digging a well with your own hands seems a rather complicated process, but if you follow all the rules, then you can easily dig a well with your own hands

Regardless of the type of well, everyone has a bottom. It needs some kind of device, and in the care, too. This is the most important element of the system, it is from its condition that the intensity of the water supply to the mine will depend. At the abandoned well, the bottom is silted, the source dies.

Wells on the site:

  • The walls of the well and the bottom must be cleaned regularly;
  • Digging is a long and complicated business;
  • There is a considerable probability of flooding the well with perchage, and that has a poor quality of water, because the water in the well can become simply unusable;
  • Water can "escape" from the well - this happens if it is dug out shallowly.

Finally, safety engineering must be at the proper level. If the shaft ring is placed in a moor, it can go to the side, and the worker may suffer. In a word, there were not any disadvantages, therefore there is something to think about.

Which is better: the difference of the well from

well

And now more about the well. Advantages of this design is that in the construction there is an easy small-size technique. Serve well may be up to 15 years. Drilling it needs only 1 day. Pumps are inexpensive, in such a water the iron content will be low. And among the shortcomings can be identified the following - a silt, not so much water supply( only 1 cubic cubic per hour), and also that it is not cheaper than a well.

It is necessary to choose the right place for the proposed drilling. The main thing is that a drilling rig can come to this place It is necessary to select the correct location of the proposed drilling. The main thing is that

drilling rig can come to this place. It's worth mentioning more about the well for limestone. Another way is called an artesian well. It can serve for 50 years, the bottom of the well may even be at a depth of 250 m, well, the diameter does not exceed 320 mm. But, of course, without a special technique, it will not be possible to drill a well. Yes, and unauthorized drilling, no one is allowed, everything needs to be agreed with the relevant authorities.

The advantages of such a well are that water is taken not from somewhere, but from a great depth. This means that perchage and various harmful microorganisms do not penetrate into this water. Water is naturally purified from mechanical impurities. The well is drilled quickly, it is hygienic, it is easy to maintain.

How to make a well in a well

It does not always make sense to do this - sometimes it is worth to drill a pit nearby. Especially if you have a team of professionals with the right equipment, drilling will be done in a short time and on an industrial scale. This will be faster than the same preparation for drilling in the well.

Drilling of the well should be performed at a low water level, that is, in the autumn-winter period Drilling squarry should be performed at a low water level, that is in the autumn-winter period

If you are going to drill a well in the well, make sure that the walls do not collapse due to this. The design should be examined, identify defects and, if necessary, eliminate them.

Drilling wells in the well:

  • It is recommended to do in the late summer, when there is less water in the soil;
  • Before the beginning of work in the very bottom of the well, a conductor, a special pipe, is often jammed;
  • After the final work, the mine is often buried so that the well is protected from sewage.

There is no separate GOST for these works. There is common sense and control of specialists who assess the appropriateness of this or that procedure. And without the pros you can not do, so do not save on it.

Well or well - which is more practical( video)

Plumbing is good, but having a well on the site is a real pleasure. Work requires both the strength, and training, and consultations of specialists. But today everything is possible, and such laborious work will please for many years.



instagram viewer