Assembly of the Mauerlat
The work on the construction of the roof begins with the installation of the Mauerlat, the horizontal bar. At the same time, the structure should be laid with a brick. All the load entering the roof must be transferred to the Mauerlat. For this, this roof element should be located 2-3 cm above the top surface of the brick.
Installation of beams and planking of boards
The next stage of construction of a gable roof involves the installation of beams overlap, i.e. beam. For their reliable fastening, nails are used for 150. First, you need to fix the outer beams. Then, long and short beams are installed.
After the installation of all the beams, you need to start planking the planks. Many will say: "Why do I need to install boards?" The answer is extremely simple. Boards are needed in order for them to walk. This will facilitate the construction of the roof.
Fastening the ridge beam
The next stage of the construction of a gable roof is the installation of a ridge beam. First, mount the racks from the boards, which are fixed by temporary spacers. After completing the construction of the entire truss farm, the intermediate racks can be safely cleaned and on the second floor you can arrange living rooms.
Assembling the rafters and installing the
rack Then proceed to installing the rafters. To do this, the support for the roof is applied to the beam and the end of the ridge beam. First you need to fix the two rakes from the opposite ends of the structure. For a high-quality and reliable installation of the system, all the same nails are used for 150.
The next action is the installation of a rack and a dead bolt. If the construction of the attic roof is meant, the racks will act as the frame of the side walls. Rigel thus become ceiling beams.
After completing the installation of the truss, you need to deal with the pediments. To do this, you need to make additional racks. Do not forget about the window opening. Thus, only after finishing the work with the frame, you can sheathe the pediment in inch.
Fibering of cornices
When making a gable roof, it is necessary to hold the cornice boards. Another no less important point is the installation of a drainage system. For these purposes, a trough of metal holders is used. Take into account the fact that it is best to install the gutter at this technological stage. If you miss the right moment, then in the future there will be a lot of problems associated with installing a drainage system. If necessary, watch a video about installing a gable roof with your own hands and then proceed to its crate.
Use a construction stapler to attach the waterproofing film. For convenience, on the perimeter of the structure, set the scaffold. This will greatly facilitate the finishing work. Also to the rafters still need to nail the slats of the rebound and do not forget to leave a place for waterproofing. And only after that, the whole surface is covered with a counterbrush. Do not forget to set up the gable ebb and ebb. On this all - gable roof made by own hands!