Usually the film coating is used for laying under a laminate, a parquet board and linoleum. To lay it on the surface is quite simple, you just need to place the butt-butt sheets. The only thing that can cause difficulties is the connection of the system to the 220-volt electrical network. So that you do not have any questions during the installation work, we recommend that you view 2 simple schemes for connecting the infrared warm floor through the thermostat.
We immediately draw your attention to the fact that it is unreasonable to make a connection without a thermostat. This device makes the heating system automatic and, moreover, allows you to save up to 40% of electricity, and this is quite a high figure when calculating the electricity consumption of a warm floor.
So, the typical scheme of connecting the film material through the thermostat looks like this: 
As you can see, everything is quite simple - the introductory phase and zero are connected to the corresponding terminal blocks on the temperature controller. Out of the remaining four connectors, the wires go to the thermal sensor and directly to the infrared heaters. A small drawback of this scheme is that the wires will intersect and get confused. To avoid this, we recommend using an alternative scheme for connecting the infra-red heated floor with your own hands:
In this case, the wiring is not so confusing. All phase conductors are set from above, and zeros are from the bottom. The system will not affect the system's performance, but at the same time, this type of wiring will secure an electrician-beginner from phase confusion and zero. A very important requirement - be careful and connect only the connectors of the same name, as shown in the diagram.
That's all I wanted to tell you about this issue. We hope that the provided electrical wiring diagrams for the warm floor heating film through the thermostat were understandable and useful for you. We also recommend that you familiarize yourself with the technology of laying the material in the video example provided below.
Related materials:
- The order of laying the warm floor under the linoleum
- Connecting the electrical wires - the 8 best ways
- How to make an independent heating of the apartment by electricity
