The flooded floors are quite popular today. This is completely justified. This type of floor has unique properties. It is characterized by durability, strength, the coating is not afraid of moisture, temperature changes, chemical compounds. It is also fireproof. High temperatures can not provoke the release of a coating of toxic substances. The operating life of the sexes is long enough. Due to their high wear resistance, they look perfect for many years. It is not difficult to take care of them. The surface is easy to clean, no extra daily care is needed. The surface of the filling floor does not promote the reproduction of microorganisms, mold, does not retain dust. By the way, it can be arranged on top of the warm floor. It is not recommended to install the floors on a wooden base.
An example of a beautiful self-leveling self-leveling floor
The technology for creating bulk floors is relatively simple. You can completely do the work yourself. It is important to carefully prepare, prepare the base.
Technology, how to make a self-priming floor
The technology of creating self-leveling floors is relatively simple. You can completely do the work yourself. It is important to carefully prepare, prepare the base.
Substrate preparation
- The surface is cleaned and leveled. Are processed places where there are oil stains. Removes traces of paint. Cement( concrete) screed is necessarily strong, not crumbling, not crumbling. When such areas are formed, they are removed, primed, filled with a soil mixture. The composition of self-leveling floors is self-flowing. Therefore, the surface of the base, naturally, should be smooth, smooth;Unevenness, depressions should be smoothed.
- After the surface is primed, it is given a roughness so that the leveling mixture adheres well to the surface. The ground is suitable for concrete contact. Other leveling mixtures are also used. Work with a brush, roller.
Priming the surface of the floor with a roller
- Preparing the room. Before removing, remove the skirting. The room along the perimeter is carefully covered with a damper tape. The optimum temperature is 10-25? .At a low temperature, the fill is not produced. Drafts should be deleted.
Preparing the working mixture
When preparing it, read the instructions. Usually water is poured into the container, the dry compound is poured out. It is necessary to mix the solution fixed in the electric drill with a stirrer.
The figure shows an example of preparing the working mixture
The resulting homogeneous solution( without clots) is used for a quarter of an hour( 15-20 min). Do not immediately prepare a lot of solution. By the way, if the mixture is prepared with hot water, then it should be used more quickly because of the fast setting of the components. It is inadmissible to use a lot of water - the ready floor will be fragile.
Application of the leveling solution
Beforehand, it is necessary to stock up with tools: a) a spatula distributing the mixture, b) a needle roller that removes bubbles, evenly distributing the solution.
Fill( narrow strip) starts at a remote corner. The leveling layer is neatly distributed with a spatula. The solution should fill any gaps, forming a smooth surface.
Removing bubbles and blisters
The needle roller carefully removes the bubbles. The layer is completely aligned. If the layer is thick, the spike is made more often, but a maximum of 40 minutes is the time of thickening. Moving on the floor can be in shoes with special thorns - on krakostupah. Gradually pouring, advance to the exit.
Self-leveling floor
