A new approach to painting the ceiling, tips the experienced masters

In this article we will talk about the new effective way to paint the ceiling, which tool is best to choose and how to prevent annoying errors when working.

Proper selection of the tool in the works

Note the following features of the selection tool, and the subtleties of painting:

• should stop its attention when choosing a cushion on instrument with a long napAt what undesirable material consideredvelor andfoam rubber, Since they causing the appearance of bubbles when painting.
• Please note, the less well-groomed surface and it is more coarse, the long pile to choose.

• To make sure that the roller is a quality just squeeze it. good quality tool return the original shape.
• When selecting a spray tool sharpen its focus on the roller surface. If you found it traces of joints - better give up such a purchase, since from it is likely to remain uneven marks on the surface.
• When pulling pile roller or brush therefrom You should not vylazit bristles.
• Choose cone-shaped brushAs it is this geometric shape helps to achieve maximum productivity results when painting.
• When staining of various surfaces is desirable to give preference to a specific model. For instance it is recommended to use a brush with a width of for painting the walls and ceiling joints 60-80 mm.

Step by step guide ceiling painting

Step 1. Provisional surface preparation. The first step is to delete old whitewash and paint. Then conducted more extensive trimming using coarse material. Carried dedusting surface. Minor defects are eliminated applying putty.

Step 2.The application of the primer layer. important stageSince without it, the ceiling will be extremely quick to absorb moisture from the environment, which will lead to defects during application and use. With such a surface the paint quickly osypetsya.

Apply the primer, then wait until it hardens, places that stand should further tint. Now we can start the final painting, but it is necessary to put a coat of primer again if necessary. We must remember that it is impossible to apply a new layer until the withered old.

Step 3.Prokraska joints and corners. These places need to paint over First and foremost. You must start the process from the distant corners of the room. Before starting the painting work should develop a brush on a hard surface, so you improve the quality of the application. Dab the brush in the paint and rub it on the edge of the container.

If necessary, repeat the procedure as a result of the brush should be wet half. Brush stained only the angles and joints, as the roll up to reach. The width of the painting surface should be 4-6 cm.

Step 4.dipping roller. After closure prokraski corners and joints should begin painting the main surface. To do this, you must first wet roller in the paint layer and hold it wringing.

At the same time completely submerged roller in the paint is not recommended, as a result of the deteriorating run-off, which leads to the appearance of smudges on the surface.

Note: immersion depth considered optimal two-thirds of the total surface area of ​​the working tool.

Step 5. direct ceiling painting. For a qualitative result should be applied uniform amount of ink across the ceiling track. To do this you need a container for paint, from which it will be convenient promakivat roll himself working tool - roller.

It should control the thickness of a single coating layer, it should not be too thick, must be applied straight stripes sequentially. The bandwidth application must be such that the adjacent layer of paint was little overlap. The spade portion of the adjacent ink stripe must be 10-12 cm.

After the end of the painting should carry out a thorough visual inspection for defects and unpainted areas. When you see them, they should be removed as quickly as possible.

Ceiling paint is a simple process, you need to use these tips to get high-quality and long-lasting result.