Fence made of polycarbonate

Fences made of polycarbonate are increasingly installed as a fence around the house.

Advantages of sampling from polycarbonate

This material has several advantages over other materials such as highflexibility, strength properties. Fencings from polycarbonate effectively look and have good light transmission, but at the same time reliably hide from outsiders the events that occur.

Required tools

Anyone who wishes to build a fence from polycarbonate with his own hands, who does not have special skills in construction. But this requires the ability to use the right tool, namely: a hand drill needed to make holes, a sledge hammer that will be required to drive the poles, a bulgarian used to cut the pipe, a building level, a screwdriver, and special nylon threads.

Installation Instructions for Polystyrene Fence

So, how to make a polycarbonate fence with your own hands, and where to start? Work must begin with the markup. Based on the perimeter of the enclosed territory, the number of sheets needed for the job is calculated. When marking, it is necessary to eliminate the unevenness of the surface.

The foundation of the enclosure must be laid taking into account the possible freezing of the soil. The depth of the foundation is usually 0.8 - 1.2 meters. The lower part of the foundation must be 200 millimeters deeper than the freezing level.

When installing poles for fence, it is necessary to perform reinforcement, which gives the foundation of concrete the necessary strength and allows you to withstand, without structural disturbances, possible soil movements. Reinforcement of the intake foundation is carried out using reinforcement, which has 10 - 16 millimeters in diameter. It is important that the reinforcement is carried out continuously.

The poles required for securing the polycarbonate web are installed after determining the required depth for their instillation. The fence posts should be mounted to the ground to a great depth, relative to the depth of the rest of the strip foundation.

So, if the trench for the base of the polycarbonate fence has a depth of 40 centimeters, the holes for the pillars need to be deepened to 120 - 150 centimeters.

When building a polycarbonate fence with your own hands, photos and video materials located here can help. Posts of metal are installed from each other at a distance of about 2.5-3 meters. Angular supports are installed in a clear vertical position, which will help the use of the level, and then poured concrete. After drying, lags are welded to the posts in the amount of two to three pieces. The polycarbonate sheet is fixed to the installed structure.

Fastening is carried out by self-tapping screws. The distance from the edge of the sheet to the drilled holes must be at least 40 millimeters. Also, the fastening can be done with bolts, glue or with the use of welding.

Mounting of sheets is carried out taking into account the stiffeners, in their direction. In this case, polycarbonate, to prevent the displacement of the web, it is desirable to tightly press against the pole. Polycarbonate sheets, if necessary, are easily cut with a circular saw or other hand-held disc tools.

The installation of the corner joint is the most difficult during the docking process. It is necessary to use the level to ensure that the sides are equal in height.

The protective film is removed from the polycarbonate after the completion of all work on the installation of the fence. To fix the ends, you can use aluminum tape. Perforated tape at the bottom will ensure unhindered drainage of water and prevent dirt from entering. That's it. The work is finished. How does the polycarbonate fence look like video and photos - see below.

Fotografie foto polycarbonate with own hands

Video fence construction from polycarbonate with own hands