What is needed to replace the lamp socket of the
lamp. In order to start work on removing the lamp socket from the cartridge, it is necessary to prepare a number of tools and materials:
- Pliers.
- Scissors.
- Pliers.
- Cellophane package.
- Gloves.
How to unscrew the socket from the cartridge:
action plan The work on removing the lamp socket from the cartridge consists of several step-by-step actions:
- Taking precautionary measures.
- Removing the bulb shell.
- Unscrewing the lamp cap with scissors.
- Chopping the chuck into parts.
- Unscrewing with pliers.
- Extraction with a plastic bottle.
- Extraction by breaking the cap.
What to do if the light bulb
is not twisted Step 1: precautions when replacing the lamp base
This step is very important, since the work is carried out in contact with a high voltage. Therefore, in the first place, you need to turn off the electricity in the apartment. This can be done by twisting the plugs or using a special toggle switch. The work should be done in rubber gloves. Tools should be used with wooden handles or wrapped insulating tape. The bare wires should be checked using the indicator.
Step 2: How to avoid injury when replacing the bulb
If the lamp that burned does not twist, then it can be broken. To do this, it is necessary to pre-package the glass envelope. Then hit the shell with a glass hammer. Thus, all the fragments will remain in the package and will not cause injury in the future.
Step 3: unscrewing the lamp base using
scissors To do this, insert the scissors in the base of the plinth and move it so that it rests against the inner surface of the plinth. Then it is necessary to rotate the scissors counter-clockwise, thereby unscrewing the cap from the cartridge.
Step 4: Split the bulb holder into parts
Most cartridges can be untwisted in two parts. After separating the upper part of the cartridge, it will be much easier to unscrew the remainder of the cap.
Step 5: How to unscrew the plinth with
pliers The glass column of the light bulb should be wrapped with a rag. Then it is necessary to put on gloves, tightly take pliers by the glass column and twist the cap counterclockwise.
Step 6: a plastic bottle for safely unscrewing the lamp socket of the
bulb to the throat before the first signs of melting. Then the molten end must be firmly inserted into the base and wait 20 seconds before the plastic solidifies.
Step 7: How to unscrew the base in pieces
If you failed to remove the socket from the cartridge by previous methods, you should try to break it. To do this, it must be grasped with wire cutters and rotated, thereby winding around them. The socle should gradually leave the cartridge.
Thus, the article described and described the ways to remove the lamp cap from the cartridge.
