Laminate repair - eliminate cracks, scratches and scrapes

click fraud protection

Laminate repair for small and deep scratches

One of the most common problems is the appearance of many small scratches that are formed from dust and sand. Also, the coating is damaged from the heels. A wax pencil is a good remedy for these defects. It is designed specifically for these purposes, available in various shades. Before you paint over the coating, you need to clean the base, then draw a pencil over the specified area. At the final stage, the surface is polished with a regular dry cloth.

Deep scratches can occur due to the movement of furniture, the falling of heavy objects. In such cases, a special putty ( sold in stores) is used. To begin with, also clean the surface of dirt and dust, then gently put the mixture with a spatula. The surplus composition is removed with a damp rag and then with a dry cloth. After processing the area to be restored, it must not be touched for at least an hour.

Also often many consumers have a question - how to repair floors from laminate, if there are scrapes? They, by the way, are formed at the entrance and in places where furniture is often moved. You can restore the laminate in this case, using a typical wax. It is also applied to the base, waiting for it to dry, and polishing the treated area. But this will have to be done during each cleaning of the coating. If this option does not suit you, you can do it differently. Shabby place is treated with nazhdachkoy and varnish.

Restoration of a laminate with raised floors

It also happens that under the influence of any factors( humidity, temperature), the laminate coating begins to expand. This can also occur due to the fact that during the installation there was not provided a technological gap( which must necessarily be present).Thus, there is a "swelling" of the floor. The only possible solution is to create enough space to expand coverage( i.e., relieve tension).

There are two ways to do this. The first is to remove the substrate that is present between the laminate and the substrate. If the problem is not solved, then remove the straps that are near the wall and cut them by 10 mm. Then fasten back. That is, an additional space is created for the subsequent expansion of the coverage. And in general, of course, it is better to think about this in advance, even at the stage of laying.

How to repair a laminate when creaks and crevices appear?

Often the question arises - how to fix a laminate, if there are crevices and creak? Such defects are observed when mounting the slats on the lock. And they appear due to the displacement of some parts of the flooring. With the slots are fighting the same as with scratches. They mask them with wax or completely change the damaged area. New slats, instead of old ones, are fixed with glue( not lock) for greater reliability. In some cases, self-tapping screws are used.

As can be seen from the above, the repair kit for laminate includes glue and screws. In the event that there are kinks, then you can not restore the bars, you will have to change them. Do this as follows: partially dismantle the coating, remove the damaged parts and put new ones. It is important to take care at the purchase stage, so that the straps are in your stock.

Note! If you want the restoration of the laminate to be carried out as sparingly as possible, initially properly install the coating( observe all technical clearances).And also be careful when operating.

instagram viewer