Starter method of switching on lamps. The basic schemes of connection of fluorescent lamps

Types of fluorescent lamps

There are several areas for ignition of this device:

1. The first area is the place where the lamp does not turn on.
2. The second area produces ignition in operation with cold cathodes
3. The third is characterized as an area with heated cathodes
4. Four uses as a cold ignition,so it can also include heated cathodes

Basic application schemes:

1. Very often in the work of the scheme with a strip. Heating of cathodes occurs from certain heated coils of an electrical transformer, such a winding runs parallel to the device.
2. Diagram including heat exchanger. To change the current in the lamp, you need to change the power, more precisely the voltage in it, and also the phase of heating the electric discharge.
3. The resistor also starts. It comes with an unstable electric voltage. Such a scheme is used when the number of lamps is small.
4. The necessary factor is the regulation of light, which occurs by replacing the power supply by a current regulator.

Lamp repair in case of failure of the

choke As you know, to connect and operate this device, you need to know what and how it is attached. In our case, the fastener is a choke. They are used as specific elements. With such throttles there are often problems, because due to voltage surges, they do not function stably.

You can buy a new cord, and just change it, but the prices for it are about the same as the fluorescent lamp itself. If the financial side does not allow, you can repair yourself. To begin with, it is necessary to remove the protective cover and the core, more precisely the two parts. We remove the winding, if there is a problem with this, you can take a knife for metal. And after all, just wrap the new throttle.

If you use a copper winding, this reduces the diameter and you can easily replace it. The rewinding of this device will take about 2-3 hours. It should be remembered that with a high power cord, it is easier to install and appropriately disassemble. If the cord is small, it takes a lot of time, energy and quality is much worse.