Installation of water-heated floor video

click fraud protection

Warm floor video editing photo

Video for repairing the apartment with your own hands. Water floor heating video installation.

This type of heating is the most suitable solution for a country house. In the same apartments in the same place in the central heating system is not allowed. It should also be taken into account that warm floors greatly reduce the humidity, therefore it is not recommended for use in sleeping rooms. Below in the video examples, see useful tips and an example of installation.

The work begins with the installation of a collector cabinet, which is necessary for the distribution of the coolant( water, most often) from the heating element to the periphery. We put in the cabinet two pipes from the boiler - the supply and return. As can be seen from their name, the first ensures the supply of water, and the second - returns it to the boiler for further heating. Direct circulation is provided by the pump. The supply and return pipes have a manifold at the ends - a pipe with several outlets, by means of which the heat supply is divorced in separate sections. It is also worthwhile to install a drain cock( in case of repair) on the collector and an air vent( removes air bubbles from the system).

Instruments
 Widget from SocialMart

Now you need to prepare the floor indoors. Removes all construction debris, if necessary, the floor is leveled. We lay a waterproofing polymer film. The edges are overlapped, then we weld them with a construction hair dryer. To prevent heat loss from above, we put a heat-insulating layer of foam or polystyrene. On the perimeter of the walls, we glue, like an adhesive tape, a damper tape, which is necessary to compensate for the expansion of the screed when heated. We lay the reinforcing metal mesh on top. We attach a metal-plastic pipe to it with clamps. The use of polypropylene pipes is unacceptable due to the large number of seams and low thermal conductivity. The main methods of laying are a spiral and a snake. The distance between the pipes can vary from 10 to 40 cm. The distance to the walls should not be less than 8 cm. The maximum permissible length of the pipe for the installation of a warm water floor is 100 m, which gives approximately 20-25 sq. M.of the paving area. We connect the ends of the pipe to the collector, at the same time we install stop valves on both sides. This will allow you to disconnect individual rooms from heating if desired. We perform a trial run of the system. The pressure at the same time should exceed the working one a half times.

You can start pouring the water floor. It is produced when the circulation system is switched on. The height of the screed is from 3 to 7 cm. The finishing coat is laid after the final drying of the screed. Optimal for use is considered ceramic tiles. It has very good thermal conductivity. If a laminate is used, the substrate layer should be as thin as possible. Carpet also requires an increase in temperature by 5 - 6 degrees.

Installation of water-heated floor video

The warm floor shows how to install a water-heated floor, instructions, tips, recommendations for installation.

https: //

Video 2 - concrete underfloor heating installation system

floor water flooring system Installation in principle is not complicated and allows saving money, because the prices for this type of work can be bitten. Good luck! Come back to the site to repair the apartment with your own hands.

instagram viewer