Damage to the drainage drainage pipe
Because of this, the liquid that is projected to flow into a special tank, where it evaporates naturally, does not enter it, but flows directly to the floor. With such a fairly common and insignificant breakdown inside the refrigerator will be dry, the amount of frost and ice will not appear in the freezer.
Most likely, the problem arose in connection with the transportation or repositioning of the device.
You can correct the situation yourself. To do this, it is sufficient to push the refrigerator, inspect its rear side and find the tube, and then insert it into a special hole in the tank. The problem is solved!
Damage or complete failure of the drainage tank
The cooling chamber will also be dry and clean inside, without excess frost and frost. The puddle will be located strictly under the refrigerator, and most likely under the rear part of it. It is necessary, as in the previous case, to push the refrigerator and examine it downstairs from the back. Usually a crack or a hole can be seen visually.
It is unlikely that you will be able to change the reservoir by yourself, even if you can find the capacity for a specific model. It is better not to experiment and call a master. Correction of such a breakdown is unlikely to incur serious expenses.
The failure lies in the system no frost
If there is water running under the refrigerator, and a lot of frost, frost and snow have formed in the freezer, the reason why the refrigerator is flowing lies in the no frost system. If the evaporator heater fails, the "symptoms" will be just like that.
In this case, the technological processes of the refrigerator, which should not necessarily form ice and do not require defrosting, are completely violated. In particular, the humidity in the freezer increases significantly, as a result of which a large layer of snow and ice builds up. Every time the camera opens, the plaque melts and drains into the drainage tank. But it, in turn, is not designed for such a volume of water and is simply overfilled.
Only the master will be able to cope with the replacement of the evaporator heater. It is better not to try to correct the problem yourself, if you have no experience of such works or you are not sure of your abilities.
Clogged in the drain hole of the refrigerator
In the refrigerator compartment there is a special hole through which excess moisture goes into the tank. If it is clogged with small rubbish or somehow blocked access to it, moisture will not go in the right direction, but will accumulate at the bottom of the refrigerator. If you do not notice why the refrigerator is running, water will appear in front of it, draining under the door.
It's very easy to fix a problem - remove the dirt from the visible part of the hole, push the debris with a thin tube for a cocktail, for example, or a water jet from a syringe without a needle.
Blockage in the drain hole of the freezer
In this case, you can notice the water both outside and inside the refrigerator, in addition, around the freezer formed a copious ice crust.
Theoretically, the problem can be solved in the same way as in the previous case. However, the drainage drain of the freezer is inside the case, and if you do not have experience of such work, and you do not want to risk, it is better to contact the master.
Slightly fitting door
In this case, the water can be seen from outside the device, and inside, and, in addition, the walls are likely to have a thin ice crust right in the refrigerator compartment. The chamber will be constantly seeped by warm air, as a result of which the refrigerator will work more actively. Along with the air, there will also be moisture, which will settle on the walls of the ice cake and will drain, constantly thawing, which will cause the refrigerator to flow.
You can help the problem by adjusting the door hinges and exposing the refrigerator to the level if it is on an uneven floor. If the problem did not dare, surely it was a worn sealant.
Worn seal
In this case, all the "symptoms" are the same as in the previous one, but they are solved only by replacing the sealant. Please note, it can be damaged both on the whole device and on separate cameras( refrigeration or freezing), then a complete replacement may not be necessary.
