How to connect the bath to the sewer

Preparatory installation works for

The installation work must include the following parameters:

1. The connection of the installation and drainage networks must be carried out with the help of certain siphons for the baths.
2. Corrugated pipes are not recommended to be used, as they are characterized by such flaws as the rapid accumulation of micropollution, the hydraulic resistance is very high, and it is also not difficult to clean.
3. It is very important to remember that the difference in height between the drain pipe and the connecting point must be made correctly.
4. The internal part of the siphon is very often clogged, and in order to do the cleaning we must place it in an easily accessible place.

Piping selection

In order to know how to properly connect the bath to the sewer, you can pick up a good and high-quality pipe. Most often for such connections, plastic pipes are used, thanks to their advantages:

1. To connect the unit to the drainage networks, it is better to use a connection that consists of 2 legs and has the required bending angle.
2. The first option is considered a very difficult connection, and not all of them come out, so you can use corrugated material.

The selection of pipes for connection to drainage networks is as follows:

1. The siphon is connected by a pipe with a diameter of 40 millimeters, only if the drainage network consists of plastic pipes.
2. If we have a sewer pipe with a diameter of about 50 millimeters, it is necessary to connect the adapter, with its help it is possible to make a transition from 40 millimeters to 50 millimeters.
3. A rubber sleeve with a size of 73/40 can also be used, but only if the sewage system is made of cast iron pipes.

Basic rules for connecting the bath

To begin with, you should follow these methods:

• It is necessary to properly assemble the siphon with the help of the instructions.
• All elements made of plastic are collected by hand, without the help of any tools, as they can damage the part.
• When everything is done correctly, one part of the pipe joins the elements we have collected, and the other to the sewer drain.
• In order to ensure that all connections are airtight, you need to do all the installation work properly.

If, at the time of installation work, any flaws or leaks are detected, they should immediately be altered, or, more precisely, eliminated. Since in the future the use of the installation will require the replacement of very important elements.

Connecting the unit to the water supply network

To connect the bath to the water supply network, you need to know a couple of basic processes, such as:

1. In order to quickly repair the mixer, you must install a special shut-off valve in front of the clutch.
2. Couplings, which are located on mixers, must be connected to eccentrics, special tapes should be used for connection.
3. You need to remember to put on the data in the sprinkler kit on the eccentric.
4. Gaskets must be inserted inside the mixer, they can be either silicone or rubber. After that, you can install the mixer.
   

   When a certain scheme is drawn up, to connect the installation, you can enter into it and check the quality of the performance of this work. Since you can see any leaks in the devices and for this you will need to change the gasket. It is possible that such a problem arose because of poor quality installation.

5. Screwing the mixer must occur immediately on both sides, so that the gaskets are sealed at the same time.
6. When purchasing a bathroom, it can be equipped already with mixers, for such an option the following rules are adopted:
   • The permissible height should be lower than the installation level, and the attachment must be reinforced with hoses.
   • The end parts of the pipeline can not be leveled, thanks to these hoses.
   • The main thing is that this hose had a longer length than the span between the installation and the

   pipe.