Connecting the hot tub to electricity

Typical location requirements for Jacuzzi

Jacuzzi should be connected indoors when the following conditions are met:

1. All repair and construction work in the bathroom must be completed.
2. The approach to the source and the device of the jacuzzi, should be available, for carrying out repair or preventive procedures.
3. There must be a wiring with grounded sockets.
4. The presence of sewage and water networks.

The correct spa device

For proper connection to the water supply network, the following requirements must be met:

1. When the device is running, the water pressure should be 4-5 atm.

When installing and connecting the scheme of the whirlpool system, it is necessary to guarantee the safe protection of hydraulic equipment, since it is expensive. Also, on the bathroom, a special device must be installed to control the pressure( reducer).

1. For the jacuzzi, special cleaning filters must be installed, since the nozzles of the installation are very sensitive to water with different impurities.
2. When the bath is installed on the legs, its water consuming devices must, is close enough to the water supply system. Further, the height of our jacuzzi must be set in accordance with the level, with the help of adjusting bolts. Also, you can install the device on the mounting frame.
3. To avoid problems with your sewer system, it is necessary to remember that the drainage bell is 10 centimeters below the drain of our installation.
4. Jacuzzi has a mixer that connects to fixed systems and is used with hoses. In this case, the distance between the bathroom and the wall is about 0, 5 meters.
5. Do not forget about the findings of water, that is, cold and hot. They must have water stop valves with thread.

The correct device of the bath to the electrical networks

When you connect the whirlpool to electricity, you must adhere to such basic rules:

1. It is necessary to adhere to the rules of technical installations, as well as the presence of an electrician is desirable.
2. It is necessary to install an outlet that will be closed to avoid water ingress.

1. The electrical outlet should be placed 30 centimeters on the wall from the side of your installation and 50 centimeters from the floor.
2. To make the wiring to your outlet, you need to use a double-insulated wire with cross sections of 3x2.5 square meters.mm.
3. To avoid overloading the mains, you can install an automatic system. Such a system will give you a guarantee that the electrical cable to your system will be in a special corrugated tube.

It is highly recommended to use the following tips when connecting the bath:

1. Do not operate the whirlpool if its sockets are not grounded.
2. Earthing is not done through plumbing, drainage and heating appliances.
3. If the bath is connected to the mains, then repair and maintenance work is not carried out.
4. The jacuzzi can not be used if the electrical cable is faulty or if there are problems with grounding.

To avoid problems with electrical equipment and for reliable operation of the equipment, it is necessary to install voltage regulators that will protect the system against power surges.

Installation and connection of the

drainage system To properly connect the whirlpool system, follow these instructions:

1. The connection must be stationary.
2. Apply a drainage sink, about 40-50 millimeters in diameter.
3. Sewage discharge must be installed according to the drawing project. The pipe can be built into the wall or under the floor, then the following rules follow:
   • If the drain is projected in the wall, then its span should be 2 centimeters.
   • The discharge of effluents should have a diameter of 40-50 millimeters.
   • When connected with discharge of sewage and drainage, it should be made with a corrugated pipe.

To comply with all the rules for installing and connecting a bath, you can avoid problems with its breakdown. It should be remembered that when you connect the whirlpool bath to electricity, you need to contact a specialist for consultation.