Finishing the premises with wood has a lot of advantages, and a lot has been written about this, including on our site "Best houses".Any construction( restoration, repair) begins not only with the drawing up of an action plan, but also with the definition of the required volume of the procurement of certain materials. Accurate calculation of the amount of lining allows you to avoid unnecessary waste and ensure the performance of the entire set of works without downtime due to lack of a facing board.
Counting is facilitated by the fact that the lining is used for flat surfaces( often baths, balconies), the dimensions of which can be easily determined by making appropriate measurements( length, width, vertical height - height).
There are two types of this material on sale - a regular board and a "euro".They differ not only in processing technology, but also in size, and this must be taken into account. All of the following numerical values are in "mm".
Lining
- The standard width of the products is 80, 100, 110, 120.
- Thickness of the board - 13,16,19.
- Length - from 500 to 6000.
Such products cost a little more. Its feature is that the profile can be of different types - block house, "American", "softline" and a number of others.
Clapboard simple
Manufacturers are not oriented to European standards, but to domestic GOST.
- The maximum width is 150.
- The thickness of the boards is from 12 to 25.
- The length is up to 6000.
Useful advices
- The board thickness of 16 mm is recommended by experts for finishing the buildings from the outside.
- When determining the right amount of material, you need to focus not on the overall width of the board, but on the useful( without taking into account the thorns, grooves).
- Do not forget that not only large enterprises that comply with all standards requirements, but also many small Manufacturers( and even "handicraftsmen") are engaged in the production of lining, for which "the law is not written".Therefore on sale quite often there is a board, which parameters differ from the designated ones. At purchase it is necessary to check up not only presence at the Seller of the corresponding certificate on the goods, but also to make gaugings of two-three samples, on a choice. Particular attention is to the thickness. If there is a discrepancy in this parameter, then it is better not to buy, because it will be very difficult to join such boards( about the best car wash for the bath read here).
- If the surface to be trimmed has a rather complex geometry, then to facilitate calculation, it must be "broken down" into triangles and their total area counted.
- Given the possibility of marriage or inaccuracies in trimming, fitting boards, you need to make a purchase with a certain excess of the calculated value( by 10 - 15%).
