Wallpaper gluing in the corners - the main
Of course, it's never hindered to preview the video "how to glue the corners with wallpaper", but a person with a good spatial imagination will be familiar with our cheat sheet.
So, the technology of gluing wallpapers in corners is quite simple and can vary depending on two factors - the type of coverage and the angle configuration. Whichever way you choose - butt or overlap - the finishing of the corners still implies overlapping one piece of another.
If you can apply gluing of flat surfaces alone, you should get an assistant to ensure an ideal result in the junction of walls, especially if the room has protruding corners that will be in sight and require irreproachability.
How to paste wallpaper on the inside or outside corner of the
Professionals recommend starting to paste the wallpaper with wallpaper not from the corner, but from a level vertical line that is strictly level. In our apartments quite often the right angles can not boast of an ideal geometry, therefore, having started work directly from the joining of the walls, it is possible after a while to understand that the entire site will have to be re-made anew. Do not worry, the first inside corner, which will remain untreated, will at one time be closed by the last cloth.
So, you successfully formed the vertical plane and approached the place of its articulation from the perpendicular - before you paste wallpaper in the corner, you need to cut off the last panel that will go to the next wall. The width of the sheet is cut off taking into account the margin from 3 to 10 cm, depending on the type of coating chosen( the thicker it is, the less the stock).If you paste a whole canvas in the corner, you need to trim the excess on the wall, otherwise too much overlap will be evident. The next whole cut must go from a perfectly flat vertical, going to the already formed part.
For finishing the projecting corners, it is important to properly remove the surface dimensions: in this case, the length and height of each of the articulated planes is measured separately and two pieces are cut out, and the allowance on each long side is left slightly less( 10-15 mm).After the work is finished, the seams are treated with a special roller.
How to glue the wallpaper in the corner - the nuances of
Different subtleties can be associated with the type of wallpaper chosen. They carry some complexity and require a certain precaution. It is better to think about such nuances before you paste wallpaper in the corner.
- So, paper wallpaper can not be strongly oversaturated with glued glue - they can not withstand additional loads and "climb" in your hands.
- Wall-papers vinyl, on the contrary, it is necessary to impregnate well before gluing in a corner. For some types of such coatings, a very "gentle" pattern can be deposited, so to ensure good adhesion to the surface( which is very important in the corners) and to preserve the appearance of the material, special rubber squeegee-hedgehogs or brushes should be used.
- When working with wallpaper on non-woven basis, the glue is applied only to the wall, but it is important to glaze the angle just before the start of work.
- Steklooboi sufficiently dense, and too much overlap in the corner may not look aesthetically pleasing.
- Features of the application of liquid wallpaper dictate its requirements, other than roll coatings, so we'll talk about them some other time.
We remind you that the gluing of wallpaper in the corners on the videos is shown very well. And if you have any questions - it is better to resolve them before the work starts.