How and what to seal the stunt in the wall

During construction or repair, it is usually necessary to lay new pipes and wiring. To do this, the walls and the floor are made of shtroby - special channels, into which the heating pipes, sewage and water pipes, as well as electrical wires are laid. In an intact form, the stroba does not look aesthetically pleasing, and the risk of their damage is greatly increased, so stitches must necessarily be sealed. Than to seal the strobes in the wall and how to choose a mixture, for putty grouting correctly.

Termination of the rod for wiring

The first step is to determine the tools that will be needed for the future work. So, how to seal the rod for wiring, you need:

1. Spatulas( usually taken 15 and 120 cm);
2. Primer;
3. Brush;
4. Building gypsum;
5. Gypsum solution( for example, Rothband).

Before direct embedding of the shroud, it is necessary to treat them with a primer. Why do this? The primer is used in order to avoid cracks in the plaster and its shedding, because there are always a lot of dust in the stitches, which prevents the plaster from adhering to the walls of the fixtures.

The primer should be applied abundantly with a large, but narrow brush, and to get to hard-to-reach places, it is necessary to pour them with a primer, making sweeps with a brush. But you need to do this carefully, so as not to slap everything around.

Next, you need to fix the wiring with the usual building gypsum. Work is done quickly, becauseWork with gypsum can be only a few minutes, and it should not be kneaded for one in large proportions. Mount the wiring is necessary with an interval of 1 meter, so it will hold tight enough.

Now you learn how to repair the strobes. For this, a plaster solution is taken and applied with spatulas in the strob. It is important to follow certain rules.

First, the solution itself should be more dense than with conventional plaster. Secondly, the solution must be applied crosswise, to the walls of the strobis, and not just vertically. So it will stick to the surface better and not create unnecessary hillocks. Thirdly, you need to remove excess solution by holding the trowel at a right angle from the outside, where the handle is located, and not flat. Thus, the gypsum solution will mesh with the walls of the strobis much better, and it will look neater, becausethe solution does not stretch past the spatula. To remove an excess solution you need 1-2 times, this is quite enough. More details about the solution can be found by clicking on the link.

Widget from SocialMart

It should be remembered that when working with gypsum or alabaster, the solution is only suitable for 5 minutes. Rothband solution will allow to work 20 minutes. Do not use the ready-made solution when it began to grasp, it has already lost its properties.

Fixing a pipe fence for pipes

Fixing a stoke in the wall for pipes is done similarly, however, instead of building gypsum for fastening pipes, a mounting foam can be used, and the pipes themselves can be insulated with a polyurethane foam or foam. Thermal insulation of pipes will avoid germination of microbes, and the foam will securely fix the pipes in the strob. In general, the whole process looks like this: the shrouds are cleaned of dust and primed, insulated pipes are installed, then they are fixed with foam, and then they are plastered with gypsum solution.

Advice from professionals

To summarize, it is worth highlighting several important points that must be observed:

• Primer. Obligatory for embedding the shtrob both for pipes and for electrical wiring ;
• Mandatory fixation of pipes and wiring;
• Plain herringbone plaster to a sample in the wall. This will ensure better adhesion of the mortar to the surface of the shroud ;
• Removal of excess mortar with a spatula at right angles.

The gypsum solution dries out, as a rule, in 24 hours. After this time, you can start painting the wall or ceiling.