Video technology pasting walls with wallpaper.
The first stage - surface preparation, cleaning, leveling( plastering cracks and holes), priming( see what primer to choose).If there are highly noticeable irregularities, then they are eliminated by the stucco mixes. The wallpaper does not hide the flaws of the walls, so the surface to be glued should be smooth and even. It is also important to know how to choose wallpaper for the room, because a variety of wallpaper provides a wide range of choices, for example there is a soundproof wallpaper for walls.
It's better to start wallpaper from the corner closest to the window. Marking the wall - from a corner, retreat a few centimeters and with a plumb, level and ruler, draw a straight vertical line. It is not recommended to align the wallpaper on the door jamb or the corner of the room, they are rarely flat and strictly vertical. See how to prepare the walls for wallpapering.
The roll is rolled out and strips of the required length are cut. If you need to adjust the pattern, next rolls the next roll, selects the pattern and cuts the strips of the desired length. This provides for proper wallpapering of the wallpaper.
Cut strips are stacked on each other face down and greased with glue. The glue is applied in a thick layer. It is most convenient to apply glue with a roller( the length of the pile is medium), but you can also work with a brush. All the canvas must be carefully etched. Pay special attention to the edges. Now there is a color glue, which after drying dries. It is convenient in application, since it is clear where it has already been glued with glue, and where it is dry. The smoothed strip of wallpaper should be folded with an accordion glue inside and leave for 5 - 15 minutes. It is not recommended to lubricate all strips at once.
Technology of pasting walls with wallpaper. While the strips are impregnated, the wall must be thoroughly smeared with glue throughout the entire height. Then we take the first "accordion" from two sides and unfold for the entire length. Glue the strip from the ceiling, if the pattern does not need to be combined, and from the middle, if you want to fit the picture. Carefully combine the edge of the canvas with vertical markings on the wall. Smoothen glued wallpaper is best with a wallpaper brush or rubber roller. Smoothing leads from the center to the edges and simultaneously from top to bottom. Thus, the air is removed from under the web and the wrinkles are smoothed. If the wallpaper from the glue is strongly stretched, the excess can be cut from below with a sharp knife. Use a clean sponge( cloth) to wipe the floor from the glue.
Locks for switches and sockets are also cut with a knife. First, cross sections are crossed into a cross, then all the resulting segments are cut out separately. The wallpaper near the holes is smooth once again.
So the next strip is glued to the joint. After gluing 4 - 5 strips you need to once again glue the edge of the edge with a brush.to know how many wallpapers you need a calculator for calculating the number of wallpapers.
Video wall papering
Website for apartment repairs with their own hands.
