How to connect a chandelier to the
control panel To connect a modern candelabrum, you first need to collect it correctly, namely:
- In the first stage of the purchase, all parts are sealed with a special film, from impact and small household scratches. It's all necessary to disassemble, unglue, fasten all the necessary elements, then insert the bulbs.
- The lamp itself includes a special receiver, various units for powering LED lamps, as well as a controller. All this should be well attached, so that nothing will fall out during installation. Most often use double-sided scotch.
Repair of the luminaire with LEDs
A very common problem is when this luminaire does not function. To begin with, you need to check everything, the batteries in the control panel, the arrival of electricity, power supplies. If after all of the above the chandelier does not turn on, it means that the fault may be a failure of the controller, that is, the receiver. You can always change the remote control and the receiver accordingly.
It is also not always recommended to use very powerful halogen bulbs for such a chandelier, from which a transformer plant or cartridges may suffer. It must be remembered that the replacement of cartridges in such a luminaire is very problematic and expensive.
Very many people do not use the controller at all from the device and conduct the connection through a conventional switch, this is the case if your chandelier does not turn on and does not work. This receiver includes two types of radio relay, which produces light on, the same function is produced by the most common switch. Therefore, if your controller is broken, you can safely connect the chandelier through the switch, just in this case the hand will be used.
The input power device itself has two wires, such as via a switch and a zero. They are designated by different wires, differ in color characteristics. Black is zero, which passes through the power supply to the zero lamp, and the phase is a red wire, it passes through the relay to the lamps, more precisely to their phases. In this case, use blue and white. The light bulbs themselves are not connected to the full, but through the nutrient blocks, but the circuit itself does not suffer from this.
