Veranda Polycarbonate own hands: 4 Simple Steps

In order to effectively increase the total area of ​​the house, many have resorted to the construction of a small portico. Subsequently, it can be used as a place to relax in the summer, in addition to this, such an extension will give your home an exclusive design touch.

building process will not create any difficulties, because all materials used are of low cost, and the time that should be spent on the construction of the structure is minimal. Below we will write out the whole sequence of actions.

Step 1. Installing the base under the veranda. The classic one is considered filling strip foundation. Veranda polycarbonate itself is quite lightweight design, which is a factor that reduces the preparation of ground-level costs. Under foundation trench sees average size on the bottom and is filled with compacted sand layer, formwork is mounted.

Next is the installation of reinforcing rods, and pouring the cement mixture. The resulting structure should be left as it is for 10-18 days.

Step 2. Installation of flooring installations and key parts of the structure. The flooring will consist of several layers of materials. First you need to fill up the sand and hold it ramming, then add a small layer thickness rubble, it install reinforcing structure which must be tied using copper wire.

This screed is filled with cement mortar, after which solidification may be carried out exterior trim. As a final material most commonly used tiles or board. Approach to the selection of the material should be responsible, as the service life is directly dependent on the quality of construction materials used.

Assembling the key parts of the design is carried out as follows:

1. Immediately mounted to the base bottom row profiles. At this stage, the corners are established, delimiting the adjacent part of the building.
2. With the help of dowels attached wall profiles.
3. Next, set the angle and the upper sections, which will be fixing the roof.
4. The final stage is considered to be the installation of structural elements, which will delimit the area of ​​location of windows and doors.

The next stage of the assembly is necessary to make the veranda made of polycarbonate.

Note! We should not forget that the need to strengthen the profile of not too much: in their intervals are mounted polycarbonate material.

Step 3. Fastening walls and roofing. This step is carried out after the installation of the main frame. You will need a sheet with a polycarbonate cover and fixing elements. At the beginning sheets are fastened, which elements fit snugly to the walls.

Then, a montage of the remaining elements of the system, it should be remembered that it is impossible to close areas where the plan are located window and door openings. For more comfortable conditions of use recommended to install an extension 2-3 windowAs well as take a seat under ventilation communication.

Once finished with the walls begin to coating polycarbonate roof. Need for installation of support profiles, which fastening material will be. Set sheets. If your plan has a window on the roof, then leave this place is not embedded.

Step 4. Installation of doors and windows. After installation of the walls and roof of the veranda you can install door and window designs. Typically the veranda windows used combinatorial materials - metal and plastic. Their use is due to a number of advantages: low weight, ease of installation, ease of service. At this stage mounted ventilation pipe with a grid.

To avoid the accumulation of rainwater are installing gutters that will be responsible for the removal of fluid from the veranda. Lower humidity indicators allow your veranda serve a significant amount of time. Now it is possible to carry out a general improvement: to arrange flowers, bring a table and chairs, set the curtains.

The installation of the veranda from polycarbonate no big deal, you need to follow our instructions and qualitative result will not bypass your side!