Quality gates on a country or a plot - a sign of security. But in addition to the strength of the design, it should be easy to use and reliable. Not very convenient, approaching the area by car, stop and get out of the cabin, to open a gate. The most comfortable to use and are relatively reliable sliding design. Consider the process of installing the sliding gate in more detail.
design Features
The main advantage of the distinctive sliding gates is that they do not steal precious space, opening up along the fence, can not be said about traditional swing designs. In addition, with proper equipment, manage them opening can be remotely or even entrust all automation.
Sliding doors are manual and automatic. The first variety is manually operated, the latter - with the remote control and motion detection.
The design of the gate depends on your personal taste and finish the fence. Thus, the sliding door can be made in form of tube sheet lined aluminum siding, block house, lining, floorings, polycarbonate, sheet metal and other materials.
Installation of gates - step by step guide
Step 1. Preparation of the working space. At the site of the gate installation should not be anything extra. Remove old designs if any, level ground, eliminate small buildings and spaces which would interfere with the work.
Step 2. Mounting of supports. On uprights fastened the main part of the structure, so the support should be durable. For racks used concrete, brick or timber tubes. Considered the most reliable pillars of concrete masonry. For tearing device supports well depth in 1m, Laid sand-gravel bed, ramming it mount of embedded metal rod or bracket.
Fill it with cement support. This should be done in stages, alternately giving grab layers. When the concrete base hardens (about 3-4 weeks), can be installed brick.
If plans to build a fence parallel installation of gates, supports are mounted around the perimeter of the site to the desired step.
Step 3. base arrangement. The foundation for the goal is better to do a tape. Zagotovte everything you need (rebar, formwork materials). From the side, where it will be mounted mechanism sliding gates, dig a trench up to the middle of the opening. The width of the trench should be at least 0.5 mAnd depth - 0.2-0.4 m.
Puts sand-gravel bed, tamped material set shuttering, reinforcement and pour mortar (the same as in the case with supports, concrete is filled in stages). The foundation for the goal to be a person from the ground level. Giving a solution to solidify, it will take 3-4 weeks. If the planned construction fence orally fill foundation around the perimeter portion in the same manner.
If you plan to install automatic door control, installation of communications need to think at the stage of foundation fill.
Step 4. Assembling the gate. In accordance with the design, manufacture of the carcass profile pipe by welding. Its cross-section can be anything: 6x3, 6x4 or 5x5 cm. It is used for the inner frame tube with a cross section of 4x2 cm. Cut elements according to size, remove rust, if present.
We are putting together the structure, process solvent, then gruntuem. To guide rail welds the bottom of the design. We clean welds cover frame with two layers of alkyd enamel.
By rivets or screws fastened to the profiled frame, polycarbonate, wall paneling, siding, or any other material selected for cladding.
Step 5. Mounting structure. We are putting on the carriage at the sill as far as possible. We put them on the frame and set it on a level. Welded to the base of the carriage. Mounted on rollers and traps, we check how to open the gate. If necessary, = design grease lubricating oil.
At the end it is to establish a system of automatic gate opening, if any project.
2017-2018. Copying of materials is possible without preliminary negotiation in the case of a direct hyperlink to our website.
