Defective spots which are formed on the iron are known to all, as even the most elite iron is not protected by a deposit. For some reason, it is formed? The essence of the problem lies in the incorrect setting of the iron when ironing of a thing. For example, ironing woolen things you need to lay a gauze cloth, and for high-quality ironing silk - put rate to the minimum temperature.
It is because of the neglect of such basic regulations on the iron plaque is formed, which, with its subsequent use, leaves a stain on clean clothes. Below we outline some fast and effective methods of combating pollution iron.
Method 1.Cleaning pen. This method is the simplest and most effective. This pencil can be bought in any household store for mere pennies - the cost of the order 25 rubles. To use it, you will not need additional funds - only iron and pencil directly.
Heat promazhte iron and its bottom portion by the tool. Once you see that the deposit began to descend, swipe missed part of the fabric, it is desirable that it was free cloth. A major shortcoming is that it means a pungent smell, which he must ammonia, a part of. This method is most effective, but not always practical. In some cases, you do not have time to go to the store and find out there cleaning pen. In this case it is necessary to turn to a proven means for years.
Method 2. Strongly alkaline soap. As this may make a normal bar of soap. Heat the iron and thoroughly coat with the lower part of the soap, when you feel that the sole has cooled, rinse the soap residue and water residue.
Method 3. The combination of the detergent and baking soda. Mix half teaspoon on one spoon of baking soda, whereby this mass is formed, causes it to iron with a sponge or cloth. Subject to this condition technique for 7-12 minutes, followed by a rag remove residues of composition and carbon from the surface.
Method 4. Salt. Choosing fine salt. Then it is necessary to pour out on paper or plain paper with a thin layer and warmed iron could move through it, simulating the ironing. After the salt will change its color to dark, you can stop the procedure. This purification method is not suitable for devices with a Teflon coating.
Method 5. vinegar. We need to take a coarse cloth, moisten it a little vinegar and then wipe the stain intensity of traffic on the bottom of the iron. Vinegar - volatile liquid, so it is necessary to moisten the cloth as often as possible. After basic manipulation to be completed, removing the need to do vinegar residues. To this heated and burning hot iron surface is wiped with a damp cloth and then another fabric is wiped on dry.
Method 6. A solution of ammonia. Turning iron, waiting until it is heated, the unnecessary damp cloth in an alcoholic ammonia solution and wipe portions, which are pollution. It is worth noting that the evaporation of ammonia produces a strong odor. The best solution is to clean with intensive ventilation.
Method 7. Hydrogen peroxide. The process is similar to the previous one. Heat the iron and wipe it with a cloth soaked in the hydrogen peroxide, after which the surface is treated with water.
Method 8. Candle of wax. Candle is placed in a cloth, iron connect to the network when it warms up, start to drive a candle in his heated part. Soon paraffin starts to melt and drain away from the surface down. It is important that the iron at the time the procedure was put upright and slightly inclined, such a position will ensure the integrity of the holes at the bottom of the iron. It is also recommended to put a pan of wax. After the completion of the purification procedure to iron fabric unnecessary to leave the wax on it.
Method 9. Toothpaste. We need to apply toothpaste evenly on the heating surface, and then connect the iron, wait a few minutes and remove any residual paste. To remedy does not beat in the holes on the iron, turn the "steaming" mode.
2017-2018. Copying of materials is possible without preliminary negotiation in the case of a direct hyperlink to our website.
