As easy to install interior doors handle in his hands - step by step guide

Few people today can imagine the interior doors with a missing handle. We use it and do not think about what it is simple, but at the same time, the important thing in every home. Not often necessary to handle in the door leaf, but when such a need arises, the question arises: how best to do?

In this article we will tell you what tools are useful for the job and how you want to mount a pen that lasts many years to come.

Tools required for installation of the handle

The list of tools is quite extensive and includes:

• The drawing pencil;
• square;
• line;
• chisel;
• screwdriver;
• drill;
• crown to tree.

Tip! Before the start of work on the installation, you should read the instructions of the door handle. It will be the main parameters necessary for correct installation.

Step by step guide mounting door handle

Install the handle will not be difficult, even a person who has never faced this kind of work, if you do the step by step instructions specified below.

Step 1.Marking points. You need to calculate the height at which the handle is positioned, to measure the distance from the floor and apply tagging. For these sketches will provide holes breaching.

To preserve the symmetry of the square and take the recommended range. With these tools, you must move the first note on the door to its opposite side.

On the edge, in the center, put a label that indicates the location where the tab will be the future of the handle. From the edges of roughly otcherchivaem 0.6-0.7 cm and draw a small point - the future handle.

Step 2.Doing a cavity for the handle. In what order do the holes is not important, the most important fold rush and focus on the process, because it is very easy to cause serious damage to the canvas.

Starting to drill holes for the handle, it needs to apply to the drill crown. To get exactly the hole and came exactly as the need to drill from the outside and from the outside. In the first, in the second case to sink into the wood material must be on half of its thickness. Do not forget to keep the drill straight, as well as to press it tightly to the surface.

Step 3.Installation of the castle. Directly mechanism is mounted in the drilled cavity. External escutcheon firmly leans against the front part and the contours of a pencil. Then with a chisel is made hollow for the laths. The surgery is performed to subsequently push it into the frame of the door. Fixing is carried out with screws.

Step 4.Setting the pen. The main difficulty here is to get the guide, with openings for bolts in the latches. By the way, such products do not require disassembly.

After it succeeded in combining the latch and the guides carried tightening screws. To handle functioned smoothly and smoothly, it is necessary to tighten gently and evenly on both sides.

Step 5.Road marking Lutkov. After mounting the handle, it is necessary to make a hole for the locking tab. Step is important because the quality markings - a guarantee of a good job and the door lock. You need to close the door, use the area and put a mark in the place where will be located the tongue pen. At this point with the tool recess to perforate it.

Step 6.Fixing laths Lutkov. Before you fix the cover, make sure that the door is tight, there are no defects in the knob. If there is friction or jamming of the tab handles need to find and eliminate the fault, only after that to finish the job. If there is a small bank door, do not worry - after installing planks, this defect will be corrected.

Screwdriver should be strictly perpendicular to the floor, then it is necessary to turn with slight pressure until complete care Lutkov.

If you did everything correctly, then you should get a quality made pen that will smoothly slide the tab and push the door tightly.