Gas water heating system on gas balloon: price, features, choice

The necessity of heating a country house or villa often causes difficulties associated with unnecessary financial costs, as well as the necessity of a long and complex and installation. However, there are alternative solutions. Consider one of the most convenient and popular options today - gas convector gas in the balloon: price, features models and operating features will be presented in the article.

For the gas which is used on a balloon gas convector

Gas-fired heaters have long been used by residents of Europe as one of the most economical device for space heating. They operate on natural gas, relieve owners from the need to have an old-fashioned stove equipment, and at the same time reduce the cost of heating. At first glance it may seem that it is easier to install a gas boiler, but in reality, the acquisition will allow the convector at times to reduce the budget for the resettlement of heating.

Gas convectors with natural gas can not be considered a panacea, because they are able to maintain the desired temperature only in a small house, the annexe or the garage. In fact, if the heating use not in the winter, but, for example, in the spring or autumn, this will enough to maintain a comfortable temperature in the room, and high-power device is not It needs.

Gas convector heating - the best solution in that case, if the house is not connected to a centralized system of power or network often power swings. Thus, you can provide a permanent housing autonomous heating. Moreover, this method is more economical times.

There are models of heaters, which initially provide the ability to use liquefied natural gas as fuel, but you must purchase a special for many models adapter. The very same gas cylinder, under proper storage conditions, can be placed directly in the house.

Useful advice!Liquefied gas in the tank can be stored outdoors. To do this you need to build a pre-metal case for him.

As working gas for heating convector

One of the main advantages that boasts gas convector working gas on a balloon - its efficiency reaches nearly 90%. In this scheme its operation is very simple: the gas combustion takes place in a special chamber, where fresh air is constantly supplied from the environment. Due to this, it supported flame which heats the heat exchanger.

In turn, the cold air from the room, getting inside the convector, faced with the heat exchanger and is heated. Warm air enters back into the room through special shutters, equipped at the top of the device. The cycle is repeated continuously and ends only when the device reaches the figure exposed labels.

It is important to pay attention to the presence of high-quality thermostat, since it allows to prevent overheating of the air in the room and spend gas reserves economically. The opportunity to exhibit the desired temperature - this is another advantage of using this particular device.

Useful advice!To prevent ingress of combustion products into the air, it is necessary to make a special outlet to the chimney.

How to calculate the power and gas convector gas consumption for gas balloon

The first criterion, which will determine the choice of the convector whether it is planned to use as a primary heat source or supplementary. Consider both options.

If the gas convector - this is the main heat source, which heats the room, for the calculations will be applied figure 40 W / m³. This means that you must use the 40 W of electrical power to heat 1 m³ of space. Further calculations are extremely simple: the amount of space is multiplied by 40, and is the instrument required power.

Often you can meet another formula for the calculation: 100 W / m². At first glance it may seem that way to settle a lot easier, but do so incorrectly. Ceiling height in suburban homes can be very different, and if we ignore it in the calculations, then bought the device eventually could simply not cope with the task.

As an example we will calculate the required capacity of the device for placing an area of ​​25 m² and ceiling height - 3.2 m Using equation, we obtain:. 25h3,2h40 = 3200 watts.

If the required power is too high, and in the sale of a suitable device is not found, it makes sense to buy two or more devices, and place them under the windows.

Placement of convectors under windows - one of the best options, as for its ability to cut off the cold air coming from the window, they help to better maintain the desired room temperature.

A second embodiment of the convector use is more common than the first. In this case the device is used as an additional heat source and working in conjunction with other devices, when their power is not enough. So, in extreme cold may be a need to include the convector, to create a comfortable temperature in the room.

If you plan to use the convector for this purpose, it should carry out calculations of the following indicators - 25-35 W / m³. Here, all the recommendations are the same, and the calculation formula is not changed. For example, for a room of 25 m² with a ceiling height of 3.2 m will be calculated as follows: 25h3,2h30 = 2400 watts.

If we talk about the flow of gas convectors gas per day, the figures here may be very diverse, depending on many different factors. As a reference use a value of 0.09 kg balloon liquefied gas at 1 kW thermal power tool.

Gas water heating system on gas balloon: the price of heating devices

Before you buy a gas heating convector, you must understand what constitutes the price and why some models can cost more than others. This primarily depends on the material from which the heat exchanger is made, and some design features. Also affect the price and quality can be devices used to control the temperature.

Useful advice!Be sure to pay attention to the fact that all documentation relating to the future operation, and was completed correctly. Otherwise you will have to repair gas convector yourself or hire a specialist at his own expense.

Heat exchanger made of cast iron, is considerably more expensive than steel. Guaranteed service life is 50 years. So in this case, the waste will be justified. As regards the design features, then under these imply a vertical or horizontal flue.

In this case, there is no difference in principle, but should be repelled from the fact that the vertical system, though has a lot of power, it can be installed everywhere. For example, the bedroom is not a suitable option from the large volume of gas burnout.

Another factor influencing the price of the device - the presence of the fan. Gas convector fan provides a more intense air circulation in the room. The price of gas fired convector too will differ from the floor model with the same parameters.

The average price for this type of devices is in the range of 20-30 thousand. rubles. However, you can find both cheap models for 10-12 thousand. rubles and more expensive devices. It depends on the capacity and availability of advanced features. More specific price convectors will be discussed later.

Review of models of gas convectors with natural gas: prices, reviews and features

Prices of gas convectors for natural gas, as well as their diversity, in no way limited. Therefore, choose the appropriate option at all today is simple. Consider the most popular models of gas heaters for questioning. Convectors these manufacturers are almost always only positive reviews.

Gas convectors Alpine Air

Wall-mounted gas heaters manufactured in Turkey occupy a leading position on the market today. They are convenient, compact, efficient and has a very affordable price. To get a complete picture of the products offered, look at a few models in the form of comparative tables.

convector	Dimensions, mm	Weight, kg	Power, W	The gas flow rate m³ / h	Diameter of smoke outlet mm	Built-in fan	heat exchanger	price, rub.
Alpine Air NGS-20	630h455h220	22	2200	0,24	150	no	cast-iron	17000
Alpine Air NGS-30F	360h455h220	22	3000	0,32	there is	19200
Alpine Air NGS-50	630h605h220	30	4900	0,51	no	20000
Alpine Air DT-5000	550h607h310	20	5000	0,46	no	steel	11900

Any of these models can be selected for use in the home. The most suitable option should pick up, focusing on the area of ​​the premises, which will be heated, as well as their own financial capabilities.

Useful advice!Do not buy too powerful device for a small room. Nothing but air overheating and excessive gas flow, it will not.

Gas convector Hosseven

Gas convector Nosseven HDU 3, perhaps the most popular representative of the Turkish company in our country. At an average cost of about 22850 rubles, he has a decent capacity of 3000 watts and is compete with similar models. Device parameters:

• dimensions: 635h470h270 mm;
• weight: 23.8 kg;
• Combustion chamber: iron;
• built-in fan is not provided in the device.

A feature of this design is that the air intake is performed through a special horizontal telescopic tube which is attached to the back side convector. Thus the device does not absorb oxygen inside the room and does not require a traditional chimney.

Gas water heating system on gas balloon: reviews and benefits

To sum up all the review of information and take into account the comments, gas convectors It may well be attributed to the best solution to the problem, as a core, and with the additional heating. Among its advantages are:

• full autonomy, independence from power supply or any other communications;
• ease of installation in comparison with gas boilers;
• economy of use, and small fuel costs;
• there is no need to equip a special boiler for installation of the device;
• there is no fear that water would freeze in the system;
• air heating process to the desired temperature happens very quickly.

Care for this type of device can also be attributed to a number of advantages. Simplicity of design allows for completely repair gas convector with his hands, if necessary, if the warranty period has expired. However, reliable to seek for professional help to avoid possible problems with leakage of gas and m. P.

Installation of gas convector own hands: video and tips for installation

In order to carry out the work on installing the wall of the gas convector without the involvement of professionals, you need a number of tools and the ability to use them:

• drill with drill bits;
• Hammer with a crown;
• screwdriver;
• polyurethane foam;
• spanners respective diameters;
• Plastic dowels and screws;
• convector;
• gas tank;
• set for the gas inlet.

First decide on the place where you plan to install the device. There are requirements under GOST: possible gas convector must be installed under the window. If due to the nature of planning is not possible, place it as close to the window.

Useful advice!It is important not only to choose the place, but make sure that you acquire the convector model fit there and will not interfere with furniture or free movement around the room.

You can then proceed to the necessary measurements and marking holes. To do this, use a tape measure and a pencil. The most important thing at this stage is to clearly define where it will be situated an inlet for gas, if you plan to install the bulb in another room or on the street.

Drill the necessary holes and push them into the dowels. With screws secure the convector on the wall. With foam seal the cracks and holes that can be sources of ingress of cool air. After that you can go directly to the connection of the gas cylinder to the convector.

Installation of gas convector completed its test run, which is produced only after you make sure that all joints are tight and there is no gas leak anywhere. After the first run is required to perform the adjustment device.

Useful advice!In the first few hours of the device going on burning chamber, with the result that you can feel the smell of burning oil. This is not harmful and can be easily eliminated by ventilating the room.

So, if you decide to buy a gas convector gas in the balloon, then you will have a difficult choice. Before you buy be sure to perform all the necessary calculations and determine which type of device suits you best. Then you can make the right choices and ensure your house, garage or outhouse warm during the cold season.