Warming balconies with their hands: step by step photo instructions

Loggia with warming in two layers

Loggia with warming in two layers

  • foam foil. This layer is of polyethylene filled with gas, soldered to the aluminum foil. This foil material without too much effort to style and cut. Enough fine structure of a heater allows you to lay it not only butt, but overlapping. Aluminum base - a kind of thermal reflector. Beating a different temperature, it increases the thermal efficiency is almost doubled.

If you plan to warming of the balcony space, it is best not to use mineral wool. Its handling is quite laborious and requires additional costs. In addition, there is a high probability of condensation, which is very undesirable can affect its technical qualities.

As an effective protection against moisture and vapor is used izofol

As an effective protection against moisture and vapor is used izofol

Please be aware that the balcony in any case it is impossible to weight. Therefore, as the insulation is best to use a lightweight foam, of a thickness not exceeding 5 cm. its cost is much lower than that of mineral wool and more modern material - extruded polystyrene foam.

Related article:

kak-uteplit-balkon-svoimi-rukami-poshagovoe-foto-12How to insulate a balcony with his hands: step by step photos and instructions. Common mistakes. Installation of windows. Insulation of walls, floor and ceiling. Warming of the balcony roof. The nuances of winter warmth.

Warming balconies with their hands: step by step photo instructions

Properly produced works on arrangement of the balcony will help you save considerably on utility bills. The heat will be stored in the apartment and not go beyond it. Main repair balconies with their hands gradually and slowly. The basic plan of action is as follows:

  1. Thorough cleaning of the balcony from foreign objects.
  2. Dismantling of old materials.
  3. Glazing.
  4. Laying electrical wiring.
  5. The choice of the insulation material.
  6. floor Warming, Walls and ceiling.
  7. Inner trim.
Pasting insulation layer may be used for planarizing

Pasting insulation layer may be used for planarizing

Important!Before starting work should immediately determine the installation of an additional heat source in the balcony. After installation of the batteries requires some preparatory work.

For glazing balconies is better to use the services of professionals, and how to properly insulate the loggia inside the home, we discussed in detail in this article. Theoretically, you can finish all the work in ten days, but in practice always comes out much longer. Be prepared for this when planning repairs.

To preserve the heat in the room should perform high-quality glazing

To preserve the heat in the room should perform high-quality glazing

Step by step video "how to insulate a loggia with their hands" can be viewed on the Internet. In the video you can see all the main stages of work, and the various nuances required for its high-quality performance.

How to insulate a floor on the balcony with his hands

Many people ask the question: how to insulate a loggia that it was warm in the winter? You should begin with the qualitative arrangement of the floor. So, the work plan:

  • carefully swept debris from all corners and potholes in the concrete;
  • seal the gap on all of the floor surface and in the connection joints. This should be done with the help of foamThe sealant or polyurethane mastics;
Wooden frame under penoplex

Wooden frame under penoplex

The technology of thermal insulation of walls and ceiling is identical to the above. On the internet you can find many object lessons on warming loggia Penoplex own hands. Step by step instructions, photos, and videos to help you understand yourself with all the subtleties of the upcoming repairs.

Warming of the floor loggia Penoplex with self-leveling floor

When using Penoplex as a heater, you should pay special attention to the foundation and floors balconies. For example, elevated humidity level immediately eliminate the use of mineral wool. After all, it can accumulate a water vapor, and it will negatively affect later on the state of your floor covering. Furthermore, it can lead to excessive moisture, mold and mildew formation.

For fixing the insulation used dowel fungus

For fixing the insulation used dowel fungus

Choosing a concrete block, remember that the amount directly proportional to the heat transfer. The higher the layer, the warmer. Therefore, if you do not need to significantly increase the level of the floor, this material is better not to apply.

An excellent choice is penoplex (expanded polystyrene). The material has following indisputable advantages:

  • low thermal conductivity;
  • moisture resistance;
  • high compressive strength;
  • durability;
  • environmental friendliness;
  • ease of mounting.
Laying Penoplex between wooden joists

Laying Penoplex between wooden joists

Useful advice!In no case do not use the foam core comprising toluene or adhesive with an organic solvent. These substances can damage the insulation.

Wall insulation and finishing of balconies in their own hands

In addition to a warm floor, on the balcony should be given additional insulation in the walls and ceiling. This will allow to keep more heat in the room. How to insulate a loggia inside their own hands, the video clip will show more detail. You can easily find it on the Internet. Phased the description of this process is as follows:

  • thoroughly clean the walls and ceiling;
  • be sure to treat the surface of the antiseptic. This will protect them from mold and mildew;
  • tamp the ceiling and walls of the boards lathing. construction height should be slightly greater than the thickness of the selected heater. To better secure the dowels should be selected with locking screws;
Constructive solution of using a loggia

Constructive solution of using a loggia

Useful advice!To insulation was qualitative purchase mineral wool of 7.5 cm, and penoplex 0.5-1 cm thick. Larger settings common to use only outdoor applications.

  • glue heater using foam cylinders;
  • Lay the top layer of plastic film or foil. This will create the necessary vapor barrier;
  • complete the electrical wires for future clarification;
  • sew on top of plastic or wood paneling. It can be used drywall, but waterproof. It must be done with the use of nails, screws or clips.
Working with mineral wool requires precautions

Working with mineral wool requires precautions

To select a coating for the walls, pre-check different Photo interior finishes loggias in the Internet. Select the most attractive in price and structure for you. Only then proceed to substantive work.

How to insulate a loggia Penoplex

Penoplex can insulate balcony surface in two ways: an adhesive and the carcass.

When insulation adhesive manner on the prepared walls and ceiling of a thin layer of adhesive (Sevener, Ceresit ST 85). Then penopleksnye neatly stacked plates. Some experts advise to spend additional strengthening by means of screws or other fastening tools. It is not a prerequisite, and remains at the sole discretion of each. Give the frame a little bit dry.

Gluing is carried out on the perimeter and the middle sheet Penoplex

Gluing is carried out on the perimeter and the middle sheet Penoplex

Above apply another layer of glue. Are installing special fiberglass reinforcing mesh (5x5 mm), and again cover the adhesive. Once construction is well dries, you can begin to various finishing activities. If you have any questions on how to insulate a balcony with his hands, step by step photos to help you understand all the nuances.

Frame method is considered more difficult and prolonged. First carried waterproofing then made insulating frame. It consists of the cellular skeleton (metal profile rail, bars), which is fixed on the treated surface. Cells tightly filled with insulating material (roofing paper, glassine), and plates Penoplex.

Installation of insulation on the ceiling is done in a staggered manner

Installation of insulation on the ceiling is done in a staggered manner

Set top vapor barrier (polyethylene), which serves as additional protection from moisture. Wood or decorative panels can be laid just above, and for wallpaper or painting required a layer of drywall.

Hear practical advice on how to equip the loggia with their hands from a few specialists, and then choose the method of warming loggia.

In addition to the insulation on the balcony it is worth considering a vapor barrier

In addition to the insulation on the balcony it is worth considering a vapor barrier

Warming panoramic balconies

Modern homes are often built panoramic balconies. They provide an excellent overview and help to avoid the primitive layout. Photos balconies, combined with a room, to help you find a new interior design solutions. For example, to create the perfect winter Garden or a cozy place to relax.

Warming of the balcony of this type begins with the careful processing of field welds. Exterior operation consist in installing the battens, internal - in sealing of cracks and dents foam.

EXAMPLE combining floor heating with a heater

EXAMPLE combining floor heating with a heater

Then, the first layer of insulating material is laid. If you choose penoplex, begin to mount the plate on the angle strictly. To do this in concrete drilled holes in them are covered by plastic fasteners (three pieces for one plate).

Chess masters recommend to comply with the order placement to improve sealing joints. All the empty spaces are filled with construction foam gently in order to avoid heat loss.

Upon contact with the air foam expands and polymerizes

Upon contact with the air foam expands and polymerizes

Useful advice!Ceiling tiles better additionally fixed with special glue. This will improve the reliability of the connection.

The next step is to create a protective layer, saving condensate. Use penofol or penolon. The sheets are stacked so that the foil side "looking" upwards. All joints are glued aluminum tape. Then start decorating.

Use of electric floor heating under the tile in the insulation loggia

Using electric underfloor heating under tiles in insulation loggia

If your balcony has panoramic windows, then take advantage of geo-line technology. It allows you to put on a glass base warm loop made from PVC structures. Implementation of these works should be entrusted exclusively to professionals.

The floor surface should be necessarily warm. You can do this with the help of electricity, paving the necessary cables or heating mats. If you do not want to have extra costs to pay electricity bills, then you should perform a more traditional arrangement of the floor. How to do it - it was described above. However, in case of the panoramic windows, insulated material and can be laid in two layers. Large glass surfaces transmit more cold than concrete walls.

Infrared film floor mounted for finishing

Infrared film floor mounted for finishing

Warming and finishing of balconies on its own - not very complicated, but time-consuming and lengthy. It is worth noting that the time and resources spent will pay off when you get a spacious, comfortable and nice room. In addition, it will serve as a buffer zone in the apartment, helping to keep extra warm in her residential area. Look on the internet video step by step instructions insulated balcony with his hands, and create a new space and the interior without spending much.

instagram viewer