Waterproofing

Waterproofing is a new generation of insulation that is widely used in many areas of construction. You can refer this material to the class of deposits.

Made of oxidized bitumen, available in rolls. Used primarily for roofing works( most often used on flat roofs);It is also used for the implementation of joints, abutments of surfaces. Has high moisture resistance properties. But it is possible to isolate walls, floors of industrial premises, garages, etc. Now it is clear what a waterproof( see photo, video), then determine its technical characteristics. If you read the reviews about the waterproofing, you can see that users in general are very satisfied with the coating, because it is durable and does not require constant maintenance.

For the production of material is used the so-called fiberglass, spec.fabric and the basis of a combined type. It should be noted that all the listed bases are not subject to rotting and biological destruction by microorganisms and insects. A bituminous coating is applied to the fiberglass mesh, resulting in a sheet of waterproofing, which is then rolled into rolls.

Species

There are two main types: P and K. The first is used for the lining of the lower, and the second top layer of the waterproofing carpet;have slightly different characteristics, therefore it is recommended to use each subset of the material strictly for the intended purpose. Only in this case it is possible to achieve the maximum protective effect.

Technical characteristics of

waterproof First of all, attention is paid to reliability, which is very high. Materials like ruberoid lose. As a consequence - a high service life, usually referred to as numbers - from 8 to 11 years. Also note the high biological resistance - insects, mold do not destroy the structure. In addition, the material is safe and non-toxic, although it is recommended for outdoor use. An important plus that the coating is inexpensive and can be used in budgetary construction for plating.

It should not be neglected that the waterproofing is quite easy to install. This does not require special qualification of workers. The instruction is extremely simple. After installation, the material does not come off, the wind is not terrible to him, since it is quite linden and adheres well to the surface of almost any texture( in spite of this, the surface is recommended to be pretreated).Let's consider the laying process in more detail.

Waterproofing

The installation takes place as follows. First of all, it is necessary to clean the surface, make technological treatment, clean( remove debris, dust, dirt).Further, the entire area is treated with a specialized solution, most often the following are used: mastic or bitumen primer. Then the foundation is laid, it is necessary to do this with special care and attention. For further installation, a gas burner or other will be needed. It is with the help of this that the waterproofing occurs. There is a specific instruction detailing each of the above points. It is recommended to use this technical manual.

Finally, you can add that the material should be stored in accordance with the standards, that is - away from sources of fire, hot batteries, pipes, etc. Rolls should be spread evenly and do not press against each other.

Video