Cheap and angry - lining plastic for outdoor works

click fraud protection

Material characteristics

Initially, the lining was used for the lining of railway wagons, where its name came from. Outwardly it is a simple board with a smooth surface and fixing grooves on the sides. However, this material is not just a board, but an element with individual cells inside. Due to this, it has good sound and heat insulation. The starting material for production is PVC, because of which the lining has a number of distinctive characteristics:

  • Longevity - the material does not rot and retains its appearance for many years;
  • Resistance to temperatures from -50 to +50 degrees;
  • Does not deteriorate from ultraviolet radiation and atmospheric influences;
  • Non-combustibility;
  • Resistance to moisture;
  • Large selection of colors and shades.

Cladding for exterior work also has its drawbacks. Its main problem is low strength. The surface, which is sheathed, is not capable of holding decorative elements heavier than one and a half kilograms. Also from a strong impact on the surface will remain dents and holes. However, the price of this material is very affordable, so replacing the damaged element will not be difficult.

Note! PVC lining for outdoor work is not recommended for use in areas of intense human flow, as the chances of surface damage increase.

Molded board for outdoor work - why is it?

Many positive qualities of this material can influence the decision to sew a lining on the outside of the building.

Firstly, it is made of polyvinyl chloride, due to which it has a glossy surface, it does not require additional processing and impregnation, as for wood panels. Also an important factor is the affordable price. The panels are presented in a wide range of colors, including imitation of a tree, which allows to realize any design intentions. Secondly, thanks to special grooves there is a qualitative and fast installation.

Important! For installation requires a perfectly flat surface and the organization of channels for the layout of communications.

In addition, the material is resistant to moisture, does not rot and is not susceptible to corrosion. It should be noted that when buying a lining, it is necessary to check whether it can be used for outdoor works. This is due to the fact that such material in the composition has special ingredients that increase its frost resistance.

Assembly of

panels The lining is installed on a pre-assembled crate. Mounting should start from the corner and guide it along the wall. The first panel is fastened with nails, which can later be covered with a decorative corner. If there is no decorative strip, then the bonnets bite off the side cutters.

Note! If you will install wooden slats, you should consider how to process the lining from the outside to protect it from moisture.

Next, all panels are inserted into the grooves and fastened. The last bar, like the first, is attached using nails. To complete the appearance at the end of the decorative elements are mounted, which cover the corners and the joint of the foundation with the walls. After this, if there is a desire, you can decide what to paint the lining from the outside. No additional protective properties paint does not add material, but you can perform the original coloring or even make a drawing on the facade of the building. To do this, it is necessary to use waterproof and strong paint, for example, acrylic, or varnish.

instagram viewer