Basic requirements for the
material Before you glue the PVC panels, consider the requirements for the finishing material. This is very important, because the place where you plan to use the paneling can simply not be suitable, as it will not meet the requirements. In addition, if this happens, you will suffer heavy losses due to material damage. So, let's go:
- It is forbidden to use PVC panels in those places where the temperature drops reach 20 degrees Celsius.
- If the temperature in the room where the material is used does not rise above 10 degrees with a minus sign, then the use of panels is not recommended.
- If the finishing material was in a room where the temperature was -10 ° C, then for some time it should be placed in the room where the panels will be used.
Warning! It is recommended to lay the material on a frame of wood, so that it is possible to lay under it heat insulation materials or sound absorbers.
- If the panels are mounted horizontally, the dowel should look down. This will prevent moisture or condensation from entering the material.
- When laying material, make sure that there are gaps of 5-10 mm at the top and bottom.
- If you are installing panels with a pattern, you should start from the left corner and go to the right. If the material is monophonic, the starting side is not important.
- When cutting panels in size, use a saw with a shallow pitch of the teeth. You can also use the bulgark with a special circle.
Now that you know the basic principles of working with the material, you can start assembling the necessary tool so that the installation of PVC panels on the adhesive goes on without interruption, so to speak, from production.
We collect the tool and purchase the required material
So, to start gluing PVC panels, you must first prepare the tool you need to work. Here's a sample list:
- You'll need a triangle's help to cut right angles.
- You can not do without a building level.
- Take up the tape measure.
- With the help of a chair you have to cut off different angles on the surface of the panels. This is the case if you plan to create a unique pattern on the surface of the wall or ceiling.
Tip! If you do not have a ladder, then you can do without an ordinary stool or chair. If, of course, you have a standard room height.
In principle, the tools were sorted out. Now you have to go to a specialized store or to the construction market. There you need to purchase:
- Directly the PVC panels themselves.
Tip! Buy stuff a little with a margin, so that you do not waste time picking the tone!
- Angles internal and external.
- Starting profiles.
- Plinth floor and ceiling. The footprint will depend on the area of your machined surface.
- Adhesive for panels.
Everything. Now you can proceed directly to the installation work.
Mounting of PVC panels on the glue - fineness of the process
Attention! To implement the venture, you need a perfectly flat surface.
If it satisfies the requirements, then we suggest considering all the finer details of the installation:
- Before the PVC panels are labeled, you need to degrease the surface to which the material will be glued, as well as the part of the panel to which the adhesive will be applied. To do this, just dilute the dishwashing detergent in the water and wipe the surfaces. After waiting for their complete drying, we proceed to the next stage.
- Now it is necessary to determine the adhesive composition for work. As it can act Moment-Mounting , Titanium or conventional liquid nails.
Important! Depending on the solution chosen, you may need a special glue gun.
- The glue is applied by a point method. The distance between the points should vary between 30-35 cm. When done, it is necessary to tightly press the panel against the surface. Next, attention, detach it and give it to stand for about 1 minute. After that, press the finishing material firmly against the surface again. The algorithm of actions is repeated for each subsequent panel.