How to cut a log on a board: circumspectness does not hurt

click fraud protection

What is to be faced when cutting logs?

Centuries and millennia pass, new materials and technologies appear, and wood, stone and metal both were, and remain the basic materials used by mankind in their needs. Products from them surround us wherever we are, wherever we go.

Especially noteworthy tree, creating everywhere an atmosphere of coziness and comfort. Metal and stone are colder and laconic, but the tree is even warm to touch. Therefore, the first two materials are used more often in the form of load-bearing structures, and the wood in the interior decoration, however, after matching.

Before correctly sawing a log, it is necessary to inspect it. If there are no significant flaws on the outside of the tree, the treatment can be carried out quickly and practically without loss of wood.

Logs must be sawn in such a way that the resulting materials have an equal density. And for this you need to remember that the wood on the north side of the trunk is more dense than in the southern side. The sawing logs along begins with the removal of the slab, this part is removed from two sides of the tree to make a beam that will not roll.

For one cut side we put the bar, and the other looks up, and the sawing begins. Now you can cut the remaining log into the corresponding lumber or boards of equal thickness. At the output, we get a set of unedged boards in which the unworked edge( sometimes even with the bark of the tree) must then be cut off with a hand saw. Now we can consider the work completed.

How to cut a log along - the disappointing realities of

All these recommendations are good for ideal logs, but as you know, the ideal is rare. Basically, almost all logs have different flaws, and you have to adjust and invent ways of cutting to avoid loss of wood and get as much quality material as possible.

As in the previous case, before cutting the log along, it is necessary to remove the slab from it. For those who do not know, croaker is a board that has one propylene surface, and the other either gets under processing partially, or does not touch at all.

After removing the slab, the next step is the unedged board, which has already been described above. Longitudinal log sawing gives the boards, but with untreated edges. In the process, becausethe log is not ideal, it is necessary to turn it periodically and identify the best options for further use. Sometimes, for cutting one log, it must be turned several times 180 degrees to minimize defective boards.

If it is possible to obtain good quality material from the other side of the log, you need to continue the process from it and so on until the wood is fully used.

Very often, after cutting, there is a bar, it can also be put on slats, boards or used in the original form.

Features of mechanisms for processing logs

Many private developers have a question: how to saw a log along the chainsaw? Experts recommend that, in order to perform this operation, first of all, fix the log and only after that perform the treatment. In addition, in order for the cut to be as smooth as possible, a good sharpening of the chain of this saw is required, so that it does not lead to the side or buy a special chain designed for longitudinal sawing.

In addition, it is desirable that the logs are not long, becausemanually from a long billet to make something very difficult. Also in building stores special nozzles for logs and saws are being sold, which are called mini-sawmills, they allow you to work at home quickly and accurately. The only drawback of such equipment is its high cost.

The use of a hand saw is the same as for a sawmill. The croaker is cut off and the remaining log is cut into longitudinal boards, in which lateral untreated edges are later separated. Only the main difference when working with a saw lies in the increased complexity, because you need to withstand a uniform thickness of the board when working with a constantly tending saw, it's also just physically difficult, to keep it in your hands all the time.

All specialists agree that if there is a possibility, it is better to divert the material to a sawmill where on professional equipment they will be processed with the least losses and extremely flat edges.

instagram viewer