How to connect a washing machine in the home?

The location for the washing machine

The excellent and safe operation of the machine guarantees, first of all, the correct installation. Because there are several options for the placement of household appliances.

The standard way involves placing it in the bathroom, but recently this place has ceased to be an axiom. And now the kitchen and even the living room can become a haven for her, as often in the bathrooms with a small area is corny there is not enough room.

Preparing for installation of the

washing machine Immediately after determining the installation site and removing the packaging, which includes removing the shipping bolts, braces and shocks, fasteners, proceed to installation. Special plugs cover all available openings.

All transport elements for fastening the machine must always be removed from the device, because the drum of the machine can be damaged and broken down to a hopeless state. And it's obvious that you do not want to break your new typewriter!

Sewerage for machine

There are certain features of connecting the machine to the drain:

1. For machines with a non-return valve to pass water in one direction, it is necessary to establish a restrictive level with a minimum and maximum value. Also, there should be a discharge hose. The photo below shows how to look at the restrictions and what is needed is the value.
2. Before you connect the washing machine and the drain system to it you need to buy a siphon. So the hose coming from the car is connected with the drainage of water from the sink to avoid any possibility of fluid leakage.
3. The drain hose is attached to the side of the sink, but it can not provide reliability, secure fastening and complete absence of leakage to the floor.
   

   Stationary drainage of water is the best solution for sewage connection. You do not need to worry about how the hoses are located, because a fixed connection guarantees reliability and security of the connection.

4. The hose should be located without kinks and be fixed at a distance of 80 cm from the floor surface on the back of the machine. Quality connection of hoses is provided by adapters with clamps.

The

washing machine is connected in the following sequence:
The connection uses three-quarter inch hoses that are as long as possible selected and fitted together with rubber gaskets or cuffs.

Next, before connecting the washing machine on its own, it is worthwhile to separate the valve:

1. Thread cutting of the water pipe. Fixing elements are installed and the threads are cut, then the valve is mounted, and after the first wash the water is closed.
2. Install a protective mesh filter. It prevents the mechanical elements from getting into the drum of the device. The filter is constantly cleaned.
   

   The water connection to the machine is made only with the use of stop valves and ball valves, which, if necessary, will serve as shutdown valves for the device. And for water supply, mixers and bends are used.

3. Hose selection. It is necessary to choose a maximum long, so that you can unscrew it before washing from the mixer and connect it to the jar of the machine.

Connecting the device via a mixer:

• The fastest way to connect a water supply, but is considered temporary or even trial.
• The machine is reliably protected from leaks when it does not work, as the inlet hose has been disconnected at this time.
• Be sure to align the machine with the adjustable feet, otherwise its operation may be disturbed.

Electrical supply for the washing machine

Wiring diagram of electricity:

• The thickness of the busbar to which the distribution board is grounded is not less than 3 mm.
• Connect using a three-wire socket with phase, ground and ground.
• Strictly insulated for earthing.

Operation of the

There are certain parameters that need to be checked before and during the first wash:

1. There should be no leaks.
2. The rotation of the drum is mandatory!
3. The tank for a certain time should be typed you need a quantity of water.
4. The operation of the drain after washing should be adjusted.
5. Spin should also function.
6. There should be no outside suspicious sounds.
7. Water should be heated 4-8 minutes after recruitment.

Now that you know how to connect the washing machine on your own, first of all, find the instruction manual for your device, learn its features, and proceed with installation with great attention.