The company DKS specializes in the release of cable management systems and electrical equipment. With the help of this product it is possible to equip office and residential spaces with electrical wiring in a modern format. Pipes made of HDPE "Octopus" allow access of electrical cables to any area of the room. And in the case of re-planning, they can easily be sent to another location, without introducing any drastic changes to the existing network. When installing electrical wiring in rooms such pipes are usually mounted in the floor to equip a place for access to the electrical connector. The logical conclusion of such a high-quality system are the "Brava" sockets and switches, which are also produced by the DKS company. Consider in this article how to install an outlet.
Contents
- Connection height of the
- socket Installation of the
- pad Installation of the
outlet
outlet height If you need to replace the existing outlet with a new one, the same place is used, only the device is installed new. But with the initial installation you need to solve a number of other issues. First, choose the most suitable place. Secondly, determine what the height of the outlet will be( see photo).Usually it is 30 cm from the floor for sockets and 90 cm for switches. When it will be decided where to put the socket, they start to mount the sub-socket.
Installation of the
chimney The chimneys differ depending on the material of the walls. There are options for drywall and concrete. Therefore, decide how to install a wall outlet in a wall in accordance with the material of the walls themselves. Before mounting the socket, it is necessary to connect the cable with the wires, it must leave the shtroba directly at the level of the socket.
If the installation is in plasterboard, it's necessary to put the parts from the first time, if it does not work, you will need to make another hole. Fastening of the podzroetnik in gypsum cardboard is carried out on the principle of "butterfly", so the diameter of the slot can exceed the diameter of the frame for the wall installation by just a couple of millimeters. But in a concrete wall, the hole can be any size, the main thing is to drown a 1-cm-long podzroetnik. And fix this part with a usual solution, for example, alabaster. In any case, you need to make sure that the length of the wires coming out of the jar is sufficient.
Installation of the
outlet Let's consider the installation of the outlet using the example of the "Brava" outlet.
Before you follow the tips given by the step-by-step instruction, you need to understand the outlet device. Each socket "Brava" has 3 component parts:
- inner case;
- decorative exterior;
- terminals.
The inner case is needed to fix the terminals, its mechanisms make it possible to fasten the whole device in the sub-socket. On the photo you can see how the power is connected. Here everything is simple: one wire is attached to one terminal( phase), and the other wire to the second( zero).If you plan to ground, a three-core cable is required. Then the third wire( usually it's yellow, green or striped) is connected to the hole in the middle. In order not to be mistaken, you can remember what the color of the wire is, where the ground is, while grounding the cable on the meter.
Assembled socket is fixed with screws, if screw connection is provided, with spacer tabs - in the absence of screw fastening. Then it remains to attach the outer decorative frame.
Such simple actions will allow you to provide the possibility of reliable and safe access to electricity.
Source: remont.dkc.ru
