Increasingly, owners of individual buildings are building autonomous water supply systems. There are many reasons, but the main ones are a higher quality of liquid and independence from its supplier. One of the main elements of the water circuit is a pump. From the correctness of its choice depends not only the reliable operation of the entire system, but also the duration of its maintenance-free operation.
One of the models that are in high demand among "private traders" is the submersible pump "Malysh".When buying, it should be borne in mind that, depending on the model of difference, there is not only the characteristics, but also the design features. Below we will consider the possibilities of this pump.
Water intake
It can be carried out from a depth of up to 70 m, regardless of which source is used: a well, an open reservoir, a well. But there are some limitations. The suction nozzle of the model "Kid" is located in the lower part of the body. It is advisable to use such products for draining reservoirs. In the modifications of the pump "M" and "3" it is on top. They are well installed in wells or wells.
Place and mounting method
When installing in a well( read about this here), it should be noted that it must be a cross section of at least 100 mm, as the diameter of all models is 76 - 99 mm( height240 - 280 mm).In addition, different products have differences in the length of the power cord( 10 - 40 m).This should be guided by the depth of immersion. It is also convenient that the "Kid" works from a single-phase 220 V 50 Hz network, so it is enough to have an ordinary free outlet for its connection.
As such, no. This is one of the main advantages of the "Kid" pump in front of many analogues, when it is required if not services, then at least a specialist consultation. It is enough to lower the product into the water, and you can immediately supply the supply voltage. In terms of operation it is also very convenient. When used in a suburban area only in the warm season, the pump without any difficulties is removed to the surface and retracted into the room until the next season.
Operation of
All users are unanimous in that "Kid" is unpretentious and reliable in use, does not require any special care. And the main thing is that all its properties have been checked by time, unlike many new products. Despite the fact that the centrifugal pumps are somewhat more efficient, crowds of those who want to part with the vibrating "Baby" are not observed.
Some site owners say that "Baby" can work even in those critical conditions, when other models give "failure."For example, with excessive silting of the well, it is often difficult to clean it, and sometimes there is simply no time. It is noted that it works faultlessly from 3 years and more, if all recommendations of the Producer for use are observed.
But if a failure has occurred, then the "Kid" is easily repaired by the owner, as the most likely cause is a malfunction of the valves, which are not difficult to replace.
Usage options
- Provides water supply to buildings with a small daily consumption.
- Drying of places of flooding( pumping out).
- Installation in the suburban areas.
- Application for spraying plantings, in drip irrigation systems.
What to look for
The practice of using the "Malysh" pumps shows that their operation has a number of limitations. According to those who already used them on their sites, it is necessary to bear in mind:
- When draining flooded areas( basements, excavations, etc.), pumping out too polluted water is not recommended, as this leads to a rapid breakdown of the product.
- The pump must be fully submerged in operation. The fact is that the cooling of the body occurs by washing with water. Otherwise, rapid overheating and consequent failure of the bearing bearings are possible, which leads to jamming of the mechanism.
- After every 1.5 - 2 hours of operation, the pump should be switched off for at least 20 minutes. Longer operation is fraught with breakage.
As an example, briefly consider several models.
- Kid M-25 ( NeoClima) has a capacity of 1.2 m3 / h with a maximum depth of 7 m. It is used in wells or boreholes, since the working position is vertical. The price is from 1 770 rubles.
- Kid-10M pumped 0.45 m3 / hour when immersed at 40 m. It weighs no more than 3.5 kg and can work in any position of the hull. The price is from 1 360 rubles.
- Kid-16M with a capacity of 0.6 m3 / h. Used only for clean liquid and in a vertical position. The price is from 1 475 rubles.
There is quite a wide range of these pumps available on sale, so the choice can be made for any occasion.
